Found this article hee hee
is it ok to post???
Give us a few seconds and we’ll give you stronger and bigger muscles. No, we’re not promising that you can work out for less than a minute (different magazine, different day). What we are promising is that if you focus on a specific range of seconds, you’ll challenge your muscles in an entirely new way. You see, while reps, sets and rest time are important variables in your workout, the total amount of time you spend actually doing each set of an exercise can also be critical to reaching your training goals. However, this time component rarely has been taken into account when putting together a weight-training programme… until now.
Time under tension (TUT) is a way of calculating the total amount of work you place on a muscle. It refers to the total time a muscle resists weight during each set. For example, if you did the barbell curl and it took you two seconds to curl the weight up and another two seconds to lower it, that’s four seconds of tension per rep. Performing 10 reps at this pace would take a total of 40 seconds. Therefore, the TUT for that set is 40 seconds. If you increased the speed of those reps to about three seconds, then it would take you only 30 seconds to complete a 10-rep set. Although the number of reps and the amount of weight are the same, the second set might not increase your muscle mass to the same level as the first. And that’s the basis of TUT training: focus on sets that last for a certain amount of time based on your training goals. For maximising strength, the ideal TUT is about 20 seconds or less; for muscle mass, it’s at least 40 seconds; and for muscle endurance, it’s at least 70 seconds.
Don’t abandon set and rep ranges just yet, though — you have good reason to focus on them. Research shows that the best way to gain muscle strength is by performing 1–6 reps per set; for muscle growth, your ideal rep range is 8–12; and for muscle endurance, 15–30 reps prove most beneficial. The problem is that all these ranges assume that each rep takes about four seconds to complete. If you extrapolated those figures, you’d assume that the best TUT ranges are 4–24 seconds for strength, 32–48 seconds for growth and 60–120 seconds for endurance. However, strength coaches and training experts have tweaked those values based on their own experience: Although no controlled research has been done on the subject, their anecdotal evidence suggests that the best TUT ranges are 4–20 seconds for strength, 40–60 seconds for growth and 70–100 seconds for endurance.
IT’S ABOUT TIME
TUT ranges allow you to be more precise about the amount of work you place on a muscle. Using the barbell curl example, if you did 10 reps at four seconds per rep, you worked the muscle for 40 seconds, which coincidentally is the optimal TUT to stress a muscle for gains in mass. But if it took you only three seconds to complete each rep (a TUT equal to 30 seconds), you weren’t training the muscle optimally for growth, even though the reps are in the proper range.
This doesn’t mean you should stop counting reps. When you’re training for muscle mass, continue to shoot for 8–12 reps. But incorporating TUT training into your routine can allow you to widen that rep range to about 6–15 per set, as long as you stay within the TUT range of 40–60 seconds. So if you decide to perform six reps of barbell curls, you would need to slow down your reps to about seven seconds per rep for a total of 42 seconds of TUT. If you did 15 reps of barbell curls, you’d need to keep the reps to about 3–4 seconds for a total of 45–60 seconds of TUT. (You don’t have to take notes: “Reps and TUT” below, will help you calculate the optimal reps, rep speed and total TUT for reaching your training goals.)
To monitor your rep speed and total TUT for every set, you need to watch the clock. If you train with a partner, have him time you with a stopwatch, help you count off reps at the right speed and keep you in your TUT window. If you train alone, however, timing gets trickier. Try positioning yourself in view of a wall clock or use a watch with a second hand or timer. You can also estimate your time by counting off with the one-one thousand system: count the time it takes to complete each rep and the set, starting with one-one thousand and counting up.
Regardless of your training goals, it’s important to vary your reps and TUT times within the range of your goal so you don’t get stuck in a rut. Make weekly modifications
Please Scroll Down to See Forums Below 
but I don't under stand the 6-7 second cadence 3:3 3:4. use small words, small LOL
