Mon 5/11/15 First Injections: ~100mcg IGF-LR3 and ~1.7g TB-500
Pinned, ate a huge meal, followed by warm-up, stretching, a few hip rehab drills and working on front squat technique. I have PT first thing tommorow so leaving gas in the tank for it. I'm realizing it will be hard to time IGF-LR3 1 hr. post workout due to my situation. If it's not feasible then I will take it in the evening or preworkout.
I recommend googling "Anatomy of a Syringe" - to see how to measure using a syringe. (basically measure from the bottom of the stopper). I shot up ~100mcg because I measured from the apex of the plunger/stopper rather than the bottom. It's an effective amount for anabolism but my primary goal is recovery and minimal side effects not anabolism.
Word of advice anyone messing with IGF-1 LR3 get .5cc syringes and as needles get blunted easily have an excess needle to syringe ratio (more needles than syringes). The graduation marks on a 3ml syringe are .1ml and the vial only holds 3ml BAC water so the smallest units I can measure in is 33.33mcg/(1/10ml) (1000mcg/3 ml/graduations). Also its hard to use only .1ml so I'll be using .2ml or ~67mcg per shot.
				
			Pinned, ate a huge meal, followed by warm-up, stretching, a few hip rehab drills and working on front squat technique. I have PT first thing tommorow so leaving gas in the tank for it. I'm realizing it will be hard to time IGF-LR3 1 hr. post workout due to my situation. If it's not feasible then I will take it in the evening or preworkout.
I recommend googling "Anatomy of a Syringe" - to see how to measure using a syringe. (basically measure from the bottom of the stopper). I shot up ~100mcg because I measured from the apex of the plunger/stopper rather than the bottom. It's an effective amount for anabolism but my primary goal is recovery and minimal side effects not anabolism.
Word of advice anyone messing with IGF-1 LR3 get .5cc syringes and as needles get blunted easily have an excess needle to syringe ratio (more needles than syringes). The graduation marks on a 3ml syringe are .1ml and the vial only holds 3ml BAC water so the smallest units I can measure in is 33.33mcg/(1/10ml) (1000mcg/3 ml/graduations). Also its hard to use only .1ml so I'll be using .2ml or ~67mcg per shot.
 
				
 Please Scroll Down to See Forums Below
 Please Scroll Down to See Forums Below 











 )
 )  There is no way to aquire, those substances legally In my country, not even for "research" purposes, and for reasons unknown, it is almost impossible to get via the "usual" les than honourable ways.
 There is no way to aquire, those substances legally In my country, not even for "research" purposes, and for reasons unknown, it is almost impossible to get via the "usual" les than honourable ways.  
 
		 
 
		 
 
		 
 
		 
 
		 
 
		 
 
		