Who all has injected what with slin pins?

[HAYEZ]

So i started injecting with slin pins last few months and i have to say it is great! no scar tissue, no soreness

only thing i have tried is test cyp and tren..anybody else do this also? if so what ?
i couldnt imagine deca working as its difficult enough to get thru a 25 gauge

 

[falcon9901]

For real dude? Is this a joke

I can only get SOME water based compounds through a slin pin (29 or 27). I cant imagine getting any oil based through it. And plus, they're not really long enough to go IM properly.

What are you trying to do?

 

[falcon9901]

I'm really curious. Has this worked successfully for you? And if so, with what compounds and IM or SubQ?

 

[HAYEZ]

For real dude? Is this a joke

I can only get SOME water based compounds through a slin pin (29 or 27). I cant imagine getting any oil based through it. And plus, they're not really long enough to go IM properly.

What are you trying to do?

no joke...if your lean enough..i do slin injects in pecs traps lats tricepts bicepts
you draw with a reg 3ml syringe...pop the plunger off the slin pin fill it and inject...pain free and no scar tissue..did last 12 weeks of ed injects like that

 

[RADAR]

I agree with Hayze!I have been saying this for years , I have done it many times with no problems, you just need to warm the gear abit, i like forearms!There I said it!
and as long as you warm it , and it's oil based your good to go that is like hayez said as long as you are lean and have muscular forearms.
RADAR

 

[Olivelawn]

Funny, I posted this type of thing up a week ago and got bashed for it by two people. Funny.

I agree with HAYEZ and Radar.

I've used it with tren, npp, and test prop.

 

[miplank]

I was tempted to try this with my test-e as the stuff I use is very thin. I'm certain it would've worked in a slin pin, but all I had were 1/2" pinz.

 

[the_alcatraz]

those damn things are too small

 

[miplank]

those damn things are too small

you prefer a whale harpoon? LOL

 

[OneBreath]

For tren and masteron i would backload slin pins for the week (drawing with a 23 gauge of course).

So then you've got your back loaded little slin pin with thick oil in it. Grab a hair dryer, hold it upside down, and "roll" the tube back and forth over the hot air. Do this for about a minute. It still takes about 50 seconds to push a CC through a 29 gauge slinpin but the benefits far outweight the inconvenience.

I've done this with some THICK oil too and it works like a charm. For frequent prop/ace injections, this is THE way to roll.

I'm ok with being called a pussy.