Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply US-PHARMACIES UGL OZ
Raptor Labs UGFREAK OxygenPharm
napsgeargenezapharmateuticals domestic-supplyUS-PHARMACIES UGL OZUGFREAKRaptor LabsOxygenPharm

I was rear ended today

PICK3

New member
I estimate the magnitude of impact to be approximately 1850-2150 psi, although I did knot have a transducer calibrated to avoirdupois units embedded in my ass at the time of collision


just sayin'
 
LOLLLLOLLLLLLLL omg im fucking dying
 
I bet it ended with a bunch of the other guy's steering fluid getting sprayed into your carburetor.
 
I drive a beige Chevy Malibu

Official ride of the tea baggers ... I mean tea party conservatives




just sayin'
 
I got a new car a couple of years ago. I got rear ended on the highway three weeks later. Two weeks after that, while still waiting for parts for the repair, I was at a gas station waiting for a guy to finish plowing snow out from between the pumps.

A couple minutes go buy, he finishes and backs out and then cuts his wheel and slams right into the front end of my car. I was livid.
 
I got a new car a couple of years ago. I got rear ended on the highway three weeks later. Two weeks after that, while still waiting for parts for the repair, I was at a gas station waiting for a guy to finish plowing snow out from between the pumps.

A couple minutes go buy, he finishes and backs out and then cuts his wheel and slams right into the front end of my car. I was livid.

I bet I've been rear ended moar than you
 
rear ended at 2150psi by a 5-axis processor must be thread worthy indeed

I warmed-up the 5-axis processor earlier this evening!

Gonna start a project soon. I'm considering going made scientist up in this bitch for a little while.
 
I warmed-up the 5-axis processor earlier this evening!

Gonna start a project soon. I'm considering going made scientist up in this bitch for a little while.

machine my ass a terminator halloween mask rob. I would take 1st place at every costume contest i entered.
 
machine my ass a terminator halloween mask rob. I would take 1st place at every costume contest i entered.

A five-axis mill could most definitely machine it, but I'd need a 3D model for it. That part would be a bitch.

The machining itself would prolly take 2-3 days, but you just get it going and go to bed anyway.

Terminator_robot.jpg
 
I think he's holding a copy of the 3D bluray of "cloudy with a chance of meatball" in that pic. Pedo?
 
Top Bottom