PCT Suggestions?

[macrophage69alpha]

with using AI's during cycle and low dose nandrolone, the use of HCG is probably not a necessity. if you do use it, 200-500iu e3d for10-14days (maintaining AI dose), followed by clomid and low dose AIFM(low dose aromasin would also be fine) for 2-3 weeks.

you can take 20mg of tamox with first 2-3 days of HCG (as a priming agent, which via half life will last through entire period). such low end use should not present a PgR issue.

the one thing you might want to add that you dont have is a low dose dopaminergic (cabaser or bromocriptine), since you have had some nipple sensitivity and were using nandrolone. Prolactin like estrogen is needed in SMALL amounts for natural test production (hence why letro or high dose AI should not be used during PCT) but more than that is counter productive.

 

[boz44]

You say to take 200-500iu e3day for 10-14 days followed by clomid. That is what I am starting tomorrow. However, I was just getting ready to mix my hcg and it says to put 2 cc's of water to total 10,000 iu's of hcg. My hgh pins are 100 units or 1cc. I fill them to the 35 mark to take 3.5 ius of gh. How do I measure out the cc's or units or iu's? I'm assuming I'm injecting this subq just like my hgh. Correct?

 

[macrophage69alpha]

so you have 5000iu's per ml. in order to take 500iu you need .1ml or 10 units.

you can also use more bacteriostatic water to get a different concentration. ie 5ml would mean a concentration of 2000iu per ml (per 100 units on the syringe or 20iu/unit)

 

[boz44]

so you have 5000iu's per ml. in order to take 500iu you need .1ml or 10 units.

you can also use more bacteriostatic water to get a different concentration. ie 5ml would mean a concentration of 2000iu per ml (per 100 units on the syringe or 20iu/unit)

So with a slin pin that is 1cc or 100 units, I would draw out to the 10 mark?

 

[macrophage69alpha]

So with a slin pin that is 1cc or 100 units, I would draw out to the 10 mark?

yes