4g Kit...enough pellets???

[jrod25]

Hoping someone could shed some light on this.

I have used Fina in the past but just recently decided to get a 4g kit (yielding approx. 50cc's), as opposed to the smaller kits I used in the past. I also got 1 Component-TH belt and 1 regular Fina cart to mix with it (all in all a total of 3 carts). Is that enough pellets for 50cc's of oil? Or, upon conversion, will this particular batch be a bit too weak when it comes to getting the maximum benfit out of the pellets?

Thanks for any input.

 

[ryan04]

I've never made fina, but I think that will give you well over 75mgs. per ml. (the normal dose) I think you're supposed to use 6 gram kits for 3 carts of fina. 6,000mgs.=6grams, and gives you 75mgs. per ml. If you use a 4 gram kit you'll probably be up around 125 mgs. per ml. I'm getting ready to make some real soon. Good luck!

 

[jrod25]

Thanks for the reply ryan.

Anybody else able to add any insight here?

 

[nydj66]

I've never made fina, but I think that will give you well over 75mgs. per ml. (the normal dose) I think you're supposed to use 6 gram kits for 3 carts of fina. 6,000mgs.=6grams, and gives you 75mgs. per ml. If you use a 4 gram kit you'll probably be up around 125 mgs. per ml. I'm getting ready to make some real soon. Good luck!

Ryan is correct; each cartridge is 2g. If you try 3 cartridges in a 4g kit there's a good chance your pellets will not dissolve in the dissolving solution. Even if they do you may have trouble keeping it all in solution once your done.

I say use the TH belt with the 4g kit to yield 50ml at 75mg/ml. Then you can buy a 2g kit for the remaining cartridge.