Please Scroll Down to See Forums Below 
Roc86
New member
So heres my story – I’ve used HCG successful 1000 times but did something silly today.
Took a shot as usual and I always use alcohol pads to clean the countertop when I set out my supplies pre-shot.
To verify its potency I used a pregnancy test (put a few drops on stick) … set down needle on counter (which had been cleaned 30 mins prior and not touched since).
After waiting a few mins on the test I grabbed the insulin pin and drew a bit more HCG and added to the test in case I didn’t apply enough. Test was positive but I then realized the second dose had been pulled using the needle which I had rest for 1-2 mins on the counters edge uncapped.
Am I worrying about nothing? Or would anyone advise throwing out the batch in case I introduced any bacteria into the vial when I took the second pull from it?
Would the bac water kill whatever may be inside at this point?
I might be overthinking this but wanted to gauge everyone opinions anyhow. Thanks for your time everyone
Took a shot as usual and I always use alcohol pads to clean the countertop when I set out my supplies pre-shot.
To verify its potency I used a pregnancy test (put a few drops on stick) … set down needle on counter (which had been cleaned 30 mins prior and not touched since).
After waiting a few mins on the test I grabbed the insulin pin and drew a bit more HCG and added to the test in case I didn’t apply enough. Test was positive but I then realized the second dose had been pulled using the needle which I had rest for 1-2 mins on the counters edge uncapped.
Am I worrying about nothing? Or would anyone advise throwing out the batch in case I introduced any bacteria into the vial when I took the second pull from it?
Would the bac water kill whatever may be inside at this point?
I might be overthinking this but wanted to gauge everyone opinions anyhow. Thanks for your time everyone
