Please Scroll Down to See Forums Below
Gauge needle?
- Thread starter Spartan25
- Start date
Faststangxxx
New member
You should use longer than 1/2" unless you are emaciated....
And you should not burry the needle incase the needle breaks. You should be doing deep muscular injects with aas.
---------------------------------
It's not roid rage, I just don't like you...
Bustin' my ass so I can save yours...
And you should not burry the needle incase the needle breaks. You should be doing deep muscular injects with aas.
---------------------------------
It's not roid rage, I just don't like you...
Bustin' my ass so I can save yours...
deejleos
New member
thecompound
Pro Bodybuilder
1/2" is fine for quads and others even the glutes if needed to. Unless you have a large amount of BF covering those spots you will hit it fine. 1 1/2 glutes is recommended,
no. this will open you up for abscesses.
use 1 inch minimum. if you do glute shots and you are a big boy i would even suggest 1 1/2.... for prop use atleast 25G, 23G is much easier though. you will notice its hard to draw using a 27G, just imagine injecting into a muscle... injections should be smooth and easy, thats why i always use a 23G.
Faststangxxx
New member
...thanks Steve. Not going deep enough will cause an access and possible infection. I'm not in the medical field or anything...
---------------------------------
It's not roid rage, I just don't like you...
Bustin' my ass so I can save yours...
A
ALIN
Guest
I doubt it will pass thru a 27 g and 1/2 just isnt deep Enough IM.
I found that the 18 gauge chews up the rubber stopper on multi-use vials too much so I switched to 20 gauge to draw.
I also find it easier to push oil-based gear through a 1" 25 gauge pin than a 1.5" 25 gauge. So at least once a week for 7 years now (HRT) I've used 25 gauge 1" (even in the glutes) and never had a problem.
This is what I use too. For five years on hrt with random cycles along the way.
ConanX
Banned
I've done dozens of shots with a 1/2" 27ga "insulin" pin.
Tren, Test, EQ, Primo.
Quads and delts. Never had one problem. Just nicer pinning with less scarring. It goes in pretty easy too. I warm my gear up by running the loaded syringe under hot water. Just make sure you have some nice muscle on the quads and you're not a fatass and I think you'll be fine pinning with the 1/2" on the quads.
Tren, Test, EQ, Primo.
Quads and delts. Never had one problem. Just nicer pinning with less scarring. It goes in pretty easy too. I warm my gear up by running the loaded syringe under hot water. Just make sure you have some nice muscle on the quads and you're not a fatass and I think you'll be fine pinning with the 1/2" on the quads.
U
UA_Iron
Guest
There's a 1.25" 27g needle out there. Excel makes it and it works well.
If you can shoot test sub-q then why would a shorter needle increase your abscess risk?
If you can shoot test sub-q then why would a shorter needle increase your abscess risk?
Skyline369
New member
id stay at 25g
johnnyboy3689282
New member
25g and 1 for me. Used 22 and 1 1/2 before... harponed me.... And 23 fucking sucks too. Did em at 1 1/2... 25g is perfect.
Similar threads
