tren enathate powder

[cybadec]

I've read alot of posts on making injectables from powder but they dont list tren enanthate. What recipe for another powder could I follow.

 

[Maetenloch]

You can use a receipe for test enanthate. If it crashes at the concentration you're trying to use, just add more BA/BB.

 

[ass_face]

I've read alot of posts on making injectables from powder but they dont list tren enanthate. What recipe for another powder could I follow.

Test Enanthate will work about the same. You may need a little more BB. I would make it at 200mg/ml to be safe. 250 can be a little on the high end depending on the powder quality and it may crash.

 

[Nytol2]

A mate of mine made some, he said he had to drop it to 150mg, to get it to hold properly, I think he used 2% BA and 20% BB, painless injection.

 

[kbrkbr]

from Harvey Baloner I believe

Tren (Powder not pellets) for 5 grams

5 grams tren powder
43.75 ml sesame oil
2.5 ml BA 5%
Syringes 3cc & 5/10cc
18 or 20 guage needles
Vial
Sterile Vial
Whatman sterile filter

1. Weigh out 5 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.

Makes 50 ml @ 100mg/ml