tren ace help

[bess01]

hey guys im new to posting here but i always read this forum and it is extreamly helpful, anyway i just got done converting fina to tren and just about everything went wrong the first filter craked and leaked out half the product all over the table so i saved as much as i could and put it in the second filter and added the vacum pressure but then had to let pressure off because the bottom chamber looked as if it was going to crack and then when everything got done filtering the septa top i bought was the wrong size so i had to leave the product exposed to air as i sucked it out with a syringe to put in sterile vials now im done and it looks clear and gold but im just afraid to use it now since everything went wrong, just looking for some opinions? thanks

 

[bess01]

anyone?

 

[BigRed66]

First of all this post probably belongs more in the bodybuilding chemistry area but no problem ur new here lik me . I can sympathize w you for worrying bout if u botched ur gear or not but with what you've described to me I see no problem if all this was done in a clean environment and you used BA correctly. I would say its fine. Good Luck bro

 

[vandelman]

So ghetto bro!!...LOL...I feel ya though....i remember how bad my first attempt at some homebrew was...it was a mistake...but i've come a long way since then...i'd say your good to go though...i always bake my homebrew just for some added safety......

 

[bigtravis]

hey guys im new to posting here but i always read this forum and it is extreamly helpful, anyway i just got done converting fina to tren and just about everything went wrong the first filter craked and leaked out half the product all over the table so i saved as much as i could and put it in the second filter and added the vacum pressure but then had to let pressure off because the bottom chamber looked as if it was going to crack and then when everything got done filtering the septa top i bought was the wrong size so i had to leave the product exposed to air as i sucked it out with a syringe to put in sterile vials now im done and it looks clear and gold but im just afraid to use it now since everything went wrong, just looking for some opinions? thanks

sounds like you pushed the solution to hard through the filter. make sure the the finish solution is still a little warm not too hot but thin enough to go through smoothly.

need a 10ml. syringe with a 20g needle. a .45 whatman filter. push plunger just enough where theres a good stedy drip.
make sure your ba is at 2% and bb @ 18-20%

 

[HAYEZ]

i would of ran it thru another whatman before injecitng that,.,,sounds like a disaster