Test without PIP?

[eyedrop]

Hello everyone! My pet rat will be doing a lot of strength training in the winter. The rat tried a cycle of test E 250mg/1ml from the hulk last year and had problems with post injection pain. No matter the administration methods and tricks, there would be horrible pip. He also tried a local source with a different product and again, the pain was horrible. I just couldn't do any leg workouts.

Is it possible to find test that won't cause pip? Ive noticed gen-shi labs has their test suspended in a clear liquid that is called elthy olate. Would this be pipless? I also noticed they have creams and gels out there. But it doesn't look like your average underground source has those.

I kind of like what test did for me but didn't like the PIP. Is there any way around this issue? Is there any way to guarantee there will be no PIP? Thank you

 

[RickRock13]

Different sources can give you less or more PIP, but there are a lot of factors that can seriously reduce it. What gauge and length of needle were you using? Did you inject slow?

 

[eyedrop]

1.5 in 23ga needle. My pet tried Equipoise alone from the same source and had zero pip. It contained the same alcohol type and amount, and looked the same. Had great results! I injected the test slow and tried warming it up but didn't help much.

 

[MaxxReps]

Test E made properly with no BB and 2% BA in GSO has virtually zero pip, unless in virgin muscle.

 

[Makaveli Tha Don]

genenerally speaking 25g is ideal for injecting. Use the 23g to draw with, then swap needles and pin with the 25g. If you aren't using a different pin to inject than what you are drawing with, this could be another reason for the pip. Otherwise just like rick said, go slow. The second you start to feel your muscle balling up and charlie horsing stop pushing on the plunger and give it a break for a few seconds. Slow it down, don't be afraid to take a good 45 seconds to a minute to pin. Afterwards rub the area in circular motions to break up the oil and not let it crystalize.

Good luck!

If you need anything for your cycle, check out ag guys

 

[RickRock13]

genenerally speaking 25g is ideal for injecting. Use the 23g to draw with, then swap needles and pin with the 25g. If you aren't using a different pin to inject than what you are drawing with, this could be another reason for the pip. Otherwise just like rick said, go slow. The second you start to feel your muscle balling up and charlie horsing stop pushing on the plunger and give it a break for a few seconds. Slow it down, don't be afraid to take a good 45 seconds to a minute to pin. Afterwards rub the area in circular motions to break up the oil and not let it crystalize.

Good luck!

If you need anything for your cycle, check out ag guys

I agree completely. Well said. This is exactly what you should do to make the PIP as minimal as possible

 

[STTM]

Step 1. Don't ever inject anything that is green.

 

[ugotmale2day]

Step 1. Don't ever inject anything that is green.

The best test e I have is GREEN lol