lookin for help from good bro's on here yet again, i have a heap of vials and some rubber stoppers they are all sealed in plastic but obviously not sterile. to sterilise them you just cook em in the oven right?
and there is no reason why test prop and mast prop cant be combined in the same vials right?
lookin for help from good bro's on here yet again, i have a heap of vials and some rubber stoppers they are all sealed in plastic but obviously not sterile. to sterilise them you just cook em in the oven right?
and there is no reason why test prop and mast prop cant be combined in the same vials right?
1. Clean your vials
a. Wash with soap and distilled water, rinsing with distilled water
b. Rinse a second time with an alcohol of your choosing. I prefer to use isopropyl. Acetone is also acceptable
2. Dry and Heat your vials.
a. Place them upside down on a baking sheet that has been properly wiped with an antiseptic.
b. Preheat oven to 350*. Place vials in oven and let set for about 30mins, allow the vials to cool to room temp and then repeat the process.
3. Soak stoppers in a hydrogen peroxide solution for a minimum of 10 mins.
Anyone this this is ok? i know i know the only way to truly sterilize is a autoclave.
Also mick, that temp is Fahrenheit, it would be around 180 Celsius
put acetone in vial (about 1/4 full).
plug top with rubber stopper.
shake tha damn thing til it drops.
dump out acetone.
microwave until the remains of the acetone are gone.