Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

IGF-1 vs HGH

ive been there. i was a student for way too long. luckily, money is not a problem at this point in my life. im about to start a nutropin depot cycle soon, if all goes as planed. it seems to be in short supply though. a friend of mine mentioned that he might be able to get his hands on IGF. i offered to buy his if his connection was legit. doesnt look like its going to happen though.
 
I haven't used Long IGF-1 R3 but have been researching it and plan to try it.

It ends up being less expensive than HGH, and the difference could be substantial.

With that disclaimer, my understanding is that now the sources are shipping it diluted in just benzyl alcohol, usually at 1000 mcg. per ml.. This does not destroy the IGF.

You don't need to be buying all kinds of acids or doing any difficult chemistry.

As I understand it, you draw out a small omount with a large pin (e.g. 18 gauge). I believe this is necessary because it is think and probably won't go through an insulin pin in the undiluted form.

Then you "backload" it into an insulin pin - pull the plunger out of the back and shoot the IGF solution directly into the barrell. You then replace the barrell and fill the ramainder of the pin with bacteriostatic water (which is available at several online stores, such as fina kits suppliers, and is not illegal). You gently mix and inject, either subcutaneously or intramuscularly.

I'm hoping to hear more real world accounts also.
 
the technique i used was to get some TB pins... they are essentially slin pins with a removable needle.

use an 18g to draw some bacteriostatic water into the pin (this is only necessary to get the liquid level in the syringe up to the point where u can acutally use the marks on the casing to accuratley measure the amount of IGF u are going to use) then draw in your IGF (if its 1mg/ml concetration, then 1iu = 10mcg)

then back into the bacteriostatic water to fill the pin the rest of the way. 2 reasons for this: 1) it lessens the pain from the BA the IGF is in and 2) the IGF dose is so small that you want to miminize the loss as much as possible due to the liquid that sticks to the side of the syringe/stopper/ left in the pin once u inject, so you use the bacteriostatic water to dilute
 
O.k., can someone give me a non-technical definition of what IGF-1 is? Is it better stacked with something, used as a bridge, etc. What are the potential side effects?
 
Diamond Bling at FG did 3 weeks at 60 mcg/day I believe. He estimated about 5 lbs of lean muscle gain, plus noticeable fat loss, especially in the abdomen (where he was shooting). Also said he felt constantly full and pumped, even though he was low carbing.
 
Top Bottom