Homebrew crashed. WTF, im confused.

[randyjones]

Im growing my own from my testosterone tree out back.

 

[Nucman]

1.) I save a ton of money
2.) I know my stuff is clean and genuine
3.) I enjoy doing it
4.) I can make, just about any combo/mg/ml I want to

To answer the 1st question, I have put prop and tren into solution w/o any BA at all at 75mg/ml, and it held. I would check my powders, maybe contaminated with base.

 

[Deleted member 33117]

LOL...I hear ya man...I only got a few more months to go...how about you?

Well, I'm a dual major now, with about 2 years to finish both, then my master's.... LoL it is going to be a little while.

 

[rev dan]

to the original pchced out.

I actualy prefer boiling the vial, this will liquify it, and maintain sterility. Baking by nature has the posibility of solidifing more of the mixture. Also if the cap is on there could be rubber contamanates, if its off contaimanates from the oven.

In case like this you can inject a "warmed solution". If your worried about strelity you can pull through the whatman then inject.
PS(you probably know this but only use one whatman for pulling, and one for pushing solution. If you try it both ways it tends to jam the little bastards)

 

[rev dan]

oh yea I forgot to say, it sounds like the solution you maid is toast. so the post above is how to salvage it.

 

[psychedout]

The gear has been filtered, and it was heated for maybe 5 minutes on a stove to make it fall into solution so I could put it into sterile vials.

BBF, this is my first time brewing up gear.

So suppose it keeps recrystalizing, I would have to heat it up everytime before injecting. Is it at all dangerous to do this, because the oil seems to be very warm, and it seems odd injecting very warm oil.

I will try boiling my gear for an hour then when I can, then post an update.

 

[Deleted member 33117]

Right, go ahead and boil it and post an update.

 

[rev dan]

You can inject it warmed, in fact for patients injection phobic, solutions were heated to ease injection,(only to body tempature)

 

[Nucman]

There is no reason to heat it up for an hr. I just made prop 133mg/ml with 5%BA and 5%BB, no problem. Ya just need to heat it up until it dissolves in solution. I steralize min at 235-250 for 15min(15min to heat up, 15 min at temp). I've done tren 90mg/ml with 2.5% BA. So 50/50 with 5/15 should be no problem. What oil are you using?? I like safflower oil, thin, less chances of an allergy. Re-check your powder, something is not right.

 

[psychedout]

Alright boys, I may have been a bit too panicky. I boiled it for about 5 minutes and now a few hours later and the oil at room temp it is all good. No crystals at all. I am still confused as to why it happened in the first place though.

Oh well, cheers.