GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Women's Discussion Board
 Clen vs. MD6
|
| Author | Topic: Clen vs. MD6 |
|
Snow White Amateur Bodybuilder (Total posts: 26) |
posted July 20, 2000 09:47 AM
  
Snow just got her first order of Clen in and decided to browse the posts about it. Since I'm half way thru my cycle, is it a good idea to stack clen?? Or, should clen be done post cycle?? I'm at 20% and want to get to 18% (I'm not greedy!) Second what is md6 and where can I get it?? Is it OTC at GNC?? Thanks to all
IP: Logged |
|
dirtyratt Pro Bodybuilder (Total posts: 126) |
posted July 20, 2000 10:37 AM
what kind of cycle are you on? winny, primo?? i would suggest doing the clen after you have finished your cycle. the clen shreds and would most likely be more affective after the juice is out. for example, i am on primo right now and feel like i have a lot of xtra water weight. if i did the clen now it wouldn't work as well because with taking the pills i am also injecting every week so it kinda evens it out. loose a little then inject and gain a little more. just my opinion though. i have used clen in the past and it is awesome. the only thing i did not like is how it make you shaky. if you don't mind that you will be fine. what kind of clen did you get? i have heard some are better than others. and for the MD6 i have never heard of it so i will do some research and let you know. dirtyratt IP: Logged |
|
Snow White Amateur Bodybuilder (Total posts: 26) |
posted July 20, 2000 10:54 AM
Im on a deca/primo/sust. MS talks about md6 in one of her posts. Need to go from 20% to 18%. I go sipropant clen. Snow [This message has been edited by Snow White (edited July 20, 2000).] IP: Logged |
|
MS Pro Bodybuilder (Total posts: 610) |
posted July 20, 2000 03:03 PM
If this is a mass cycle, then leave the Clen until afterwards. I would recommend Adipokinetix over MD6, mainly because of cost. But if money is no issue, then MD6 is good too. They can both be purchased from www.Netrition.com, or you can get MD6 direct from Biotest.com. I don't know where to buy it OTC in the US. IP: Logged |
|
lala Amateur Bodybuilder (Total posts: 19) |
posted July 20, 2000 03:18 PM
Snow, Is the spiropent in .02 mg tabs. How are you going to take this? How many tabs a day? How much did you pay for them, i hope you don't mind me asking? I might take them soon- but I still have to do some research. IP: Logged |
|
Snow White Amateur Bodybuilder (Total posts: 26) |
posted July 20, 2000 03:31 PM
Lala, Is the spiropent in .02 mg tabs. YES How are you going to take this? Orally How many tabs a day? ONE AT 6 AM AND ONE AT 4PM. How much did you pay for them, i hope you don't mind me asking? 50$ FOR 100. I might take them soon- but I still have to do some research. IP: Logged |
|
4drkk78 Amateur Bodybuilder (Total posts: 39) |
posted July 21, 2000 10:50 AM
stick with the adipok or lipok the MD6 is to expensive and it doesn't work. IP: Logged |
|
Snow White Amateur Bodybuilder (Total posts: 26) |
posted July 21, 2000 10:56 AM
Where od I get adipok or lipok??? IP: Logged |
|
dirtyratt Pro Bodybuilder (Total posts: 126) |
posted July 21, 2000 12:17 PM
lala- check into novagam clen. i heard it was the best. i used it and loved the results. if you can find it for a good deal get it! good luck ladies. dr IP: Logged |
|
lala Amateur Bodybuilder (Total posts: 19) |
posted July 23, 2000 02:39 PM
snow, How many weeks are you going to take your cycle of clen? 2wks on 2wks off, for how many wks? And if I read correctly you're only taking 40 mcgs of clen daily? Did you find the adipo, it's about $19 dollars at dpsnutrition.com. I start my cycle tomorrow.
1wk - 20 mcg of clen tab daily Then I'll finish up my adipo. What do you think? Do you know if that is enough clen to lose some fat? I have 60 clen tabs of 20mcg. Should I get more? thanx, lala IP: Logged |
|
lala Amateur Bodybuilder (Total posts: 19) |
posted July 24, 2000 01:15 AM
bump... IP: Logged |
All times are ET (US) | |
 |
| |