GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 using primo at end of cycle
|
| Author | Topic: using primo at end of cycle | ||
|
Amateur Bodybuilder 
Posts: 57 |
What are some opinions on using primo at end of cycle to hold down gains? I am caught between using nothing but clomid or using primo in lose dose per week after cycle. Maybe bridging to my next cycle. I'm kinda under the impression it's best to quit cold turkey with clomid until next cycle. Somebody who knows steer me in the right direction, although I'm leaning towards quitting cold turkey. 'preciate it.     | ||
|
Amateur Bodybuilder
Posts: 75 |
bump........i'd like to know too | ||
|
Amateur Bodybuilder
Posts: 204 |
You can run 100mg primo/wk or do some EQ if you want to bridge until your next cycle. It is best if you go completely off and get all of your hormones back functioning correctly, and just do a good session with clomid. Personally, I would taper with the primo maybe once or twice, and after about two weeks after your last test injection, wait another two weeks, and then do up the clomid, and then see where your body holds. Clean up, get back to normal, wait seven or eight weeks, and then start again. | ||
|
Amateur Bodybuilder
Posts: 206 |
run primo at 300mg-400mg and bridge to your next cycle if you got money primo doesnt interefere with HPTA function so you should be fine | ||
|
Elite Bodybuilder 
Posts: 818 |
Bridging with 200-400mg of primo a week to maintain gains between cycles is a fine idea. Primo is the ultimate bridge as at low yet effective dosses it won't interfere with endogenous hormones. It most likely will not aid in any new muscular hypertrophy but it will preserve your hard earned muscle mass quite well and safely. ------------------ |
All times are ET (US) | |
 |
|
|
posted December 28, 2000 09:44 AM