GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Your opinion on this Fina procedure
|
| Author | Topic: Your opinion on this Fina procedure | ||
|
Elite Bodybuilder 
Posts: 931 |
I was asked if this method for making Fina injections would work. Any opinions. Add 2 grams ground fina to 5 mls ethyl alcohol. heat at low temp and swirl for an hour. Resulting solution is 400mg/ml. Take .15 mls add to 1-3 cc of your favorite roid oil and pop it! 60mgs fina clean sterile per pop. Add .25 mls and get 100mg/ml. It stings a little but damn it is potent! No kit needed-you can get the ethyl alcohol at a drug store.     | ||
|
Amateur Bodybuilder 
Posts: 103 |
what about the glues and fillers, aren't they still in there, if so you are injecting that crap, right? | ||
|
Pro Bodybuilder 
Posts: 555 |
This procedure will work, except for the initial volume. You will need more than 5mls, if you intend to heat it, unless you wish it to evaporate away in nothing flat. Start out with 15mls and then concentrate down to 5mls. The ethanol is an effective sterilizing agent. As for the tableting binders and fillers, they are non-toxic, so this is of no concern. | ||
|
Elite Bodybuilder
Posts: 931 |
Thanks , Anymore comments? | ||
|
Novice 
Posts: 6 |
100 pallets = 2 grams ? | ||
|
Amateur Bodybuilder
Posts: 257 |
YES 100 PELLETS WOULD BE 2 GRAMS!! ------------------ | ||
|
Amateur Bodybuilder
Posts: 199 |
Sounds like a regular fina kit without the Magic Oil. It seams like it would work. I myself don't want to inject the glues. Would the alchol solution with the fina break down the same way as A's kit? How about the powdered products. Would a vial of B12 work? Take a 5/10ml sryinge pull out 2/3 of the sryinge with b12. Take the plunger out and pour in the powder. Swirly it around abit a place back into the vial. Might take a few times to mix it all up and have the Mg/ml down good. Sure would save alot of money.. . | ||
|
Novice
Posts: 1 |
Correct me if I am wrong but if you didn't have fillers and binders you could have more trenbolone acetate per cc of oil. It's not that much more difficult to crush the pellets up, mix with methanol, and filter through a coffee filter and let methanol evaporate. (no kit needed) Take this mixture add to expeller pressed sunflower oil (anymore than 80 mgs per cc won't allow passage through a 23gauge pin due to the greater molecular weight)--reference the Merck index of other gear. Put in microwave, heat to 180degrees, kills any bacteria. Add 3% of total mixture-benzyl alcohol for preservative and prevents abcesses obviously. Anything less than this is really taking a risk. Just my .02. This advice was given to me by an old Masters' competitor that had been doing this for awhile. Hope this helps. |
All times are ET (US) | |
 |
|
|
posted December 20, 2000 08:11 PM