GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 T3 low doses for bulking and cutting without gear.
|
| Author | Topic: T3 low doses for bulking and cutting without gear. | ||
|
Amateur Bodybuilder 
Posts: 182 |
Well, what do you T3 experts think of T3 for bulking without gear? In the supplement regimen 25-50 mcg.per day. Also, would it be beneficial to use T3 in these small amounts combined with a non gear cutting cycle, eg. 4-7 clen per day + 25-50 mcg. T3 per day.?? Thanks all, ------------------     | ||
|
Amateur Bodybuilder
Posts: 53 |
T-3 might burn off too much muscle if you aren't juicing. Expecially if you are bigger than your natural limit. T-3 is a pretty potent drug. I would save it for your most serious cutting cycle. I wouldn't use it while bulking. T-3 just encourages your body to waste calories and burn muscle. If you gain too much fat while bulking, eat less. There is no reason to gain more than 3/4 of a pound of fat per week while bulking. | ||
|
Amateur Bodybuilder
Posts: 61 |
I am bulking right now and am picking up some fat. I started t3 this week. 1st day was 50mcg and I am taking 12.5 mcg a day. It's been five days and my wife has already commented that my waist looks tighter. | ||
|
Amateur Bodybuilder
Posts: 182 |
NUTZZ, Are u using gear?? The other bro, I'm referreing to T3 in low doses such as 25 - 50 mcg. per day, it's not so much for fatburning in this amount, more for enhanced protein synthesis. Anyone knowledgable on the subject has something to share?, WARLOBO ARE U THER  ??Mike H / VIKING OF THE NORTH. | ||
|
Amateur Bodybuilder
Posts: 61 |
yeah, I am using gear. I don't consider 25mcg or more a low dose though. 12.5mcg is a low dose that hopefully won't inhibit my natural t3. | ||
|
Moderator 
Posts: 1866 |
Yah, I'm here :P Looking into it.... ------------------ Lobo |
All times are ET (US) | |
 |
|
|
posted December 15, 2000 06:52 PM