GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Dumping gear into the back of the syringe barrel?
|
| Author | Topic: Dumping gear into the back of the syringe barrel? | ||
|
Amateur Bodybuilder 
Posts: 57 |
Obviously this won't work with a multi-use vial, but what about amps? I'm sick of drawing up 3 cc's of primo through a 25 guage pin. Instead of looking for some 18 guage pipes to draw it with, I was thinking about pouring the contents into the plunger end of the syringe. Once an amp is broken, the gear is no longer technically sterile anyway, so I see no issues if I pour the contents into the back of a sterile syringe. The only problem might be glass, but I always get clean breaks, and I doubt glass would squeeze through a 25 needle anyway. Anyone out there do it this way? Or am I missing something??     | ||
|
Novice 
Posts: 10 |
i used to do that with my sust but i ended up wasting some gear. the way amps are shaped it makes it hard to pour the gear into the sirynge. the oil gets "trapped" right on the opening of the amp because of its thick consistency and the shape of the amp doesn't help either. but i don't know how thick primo is, so you can give it a try. | ||
|
Cool Novice 
Posts: 40 |
Its not the thickness of the gear that keeps it in the amp, they are designed that way. They are sealed in a vacumn, so you can break the top off, turn it over, and it wont pour out. It is the same with water based drugs. The only way that the liquid will pour out is if you break that vacumn, ie. push some air into the amp. However, you are right about the oil, it will be a bitch to pour. Draw it up the way you always have been. Just sing a little song to help the time go by. ~Insominac ------------------ | ||
|
Pro Bodybuilder 
Posts: 566 |
Simple solution. Buy an 18,19,20 gauge pin, use that to draw up and then just change the pin to a 25 or whatever you use when done. I do this with all my injects cause it ensures the pin is sharp and pointed when injecting ------------------ You may be disappointed if you fail, but you are doomed if you don't try |
All times are ET (US) | |
 |
|
|
posted December 13, 2000 09:23 AM
