GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 HEATING JUICE
|
| Author | Topic: HEATING JUICE | ||
|
Amateur Bodybuilder 
Posts: 144 |
Have any of you guys ever heating your juice to prevent the sting? (test susp, prop, or sust) I heard it kills the compound, is this true?     | ||
|
Pro Bodybuilder 
Posts: 546 |
I've heard of heating to reduce viscosity and make the inject easier. Never heard of it to "reduce the sting" unless you mean the same thing. AS are very stable molecules and reasonable amounts of heat won't harm them. Peace! ------------------ | ||
|
Pro Bodybuilder
Posts: 404 |
I run my gear under warm water to make it thinner so it is easier to inject. I use 25g pins. Never used prop or susp so not sure about pain. I mix my sust with Deca never felt any pain. ------------------ | ||
|
Cool Novice 
Posts: 49 |
I always use a hair dryer to heat mine, shit just heat it to about body temp and it wont hurt them. | ||
|
Elite Bodybuilder 
Posts: 1376 |
I drop a vial in a cup of hot water before uncaping it. . .works like a charm and makes it pass through a 22gg much faster. OIL only boys. ------------------ | ||
|
Pro Bodybuilder
Posts: 530 |
i think hes talking about oil thats made in bulk from a certain someone, and you heat it up to evaporate all that alcohol in it(that so called sting) ------------------ | ||
|
Amateur Bodybuilder
Posts: 165 |
I like to put water on a clean wash cloth Zap it for about 60 seconds and place the pin in the fold for a few seconds. Heats the hole pin up to a nice warm temp and slides right in... | ||
|
Cool Novice
Posts: 15 |
I usually just put them im my pants pocket for 10 mins or so. That warms them up nice.
"I THINK, THEREFORE, I LIFT..." | ||
|
Amateur Bodybuilder
Posts: 144 |
I meant, to evaporate the alcohol and sterilize it more. |
All times are ET (US) | |
 |
|
|
posted December 09, 2000 04:32 PM