GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 EASING THE PAIN AFTER INJECTION???
|
| Author | Topic: EASING THE PAIN AFTER INJECTION??? | ||
|
Amateur Bodybuilder 
Posts: 54 |
ANY GOOD TIPS. IM USING SUSPENSION. TATOO    | ||
|
Elite Bodybuilder 
Posts: 998 |
heating pads.... rubbing  | ||
|
Guru 
Posts: 3701 |
Well I have a few. 1.go do legs 2.sit in the bath tub"hot water" 3.heating pad 4.sauna 5.message the area alot"or your girl" 6.inject with something else"b-12 really works good" 7.go to sleep and put heating pad on it during the nite. Thats all I can think of good luck just keep the area busy with blood flow ------------------ Lift | ||
|
Elite Bodybuilder
Posts: 722 |
masg the area,hot watear,do some running. ------------------ | ||
|
Elite Bodybuilder
Posts: 711 |
all of the above and ibuprofen is ideal for this also. ------------------ | ||
|
Amateur Bodybuilder
Posts: 172 |
microwave water for ten min. then let the amp sit in the water for about 5 min, I hope it helps | ||
|
Pro Bodybuilder 
Posts: 437 |
When I first started injecting I had so god damn much pain that I had tot ake the next couple of days off working due to not being able to walk. I switched from a 21g 1.5 inch to a 23g 1 inch, try not to move the needle around at all once it is inside. Get some help if you can (i.e. you hold the syringe and someone else injects and withdraws for signs of blood). Directly afterwards massage the area for about 10 minutes and then excercise the muscle you injected into. (I always do quads and squat with one leg using only my bodyweight and a chair in the house). Try injecting and then working out that muscle just afterwards it helps. & as Big Jay mentioned try mixing something with it. ------------------ You may be disappointed if you fail, but you are doomed if you don't try |
All times are ET (US) | |
 |
|
|
posted December 05, 2000 03:15 PM
