GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Need advice from some veterans
|
| Author | Topic: Need advice from some veterans | ||
|
Novice 
Posts: 8 |
Could you guys give me some advice? I plan on starting a mass/cutting cycle soon. - I have 4 carts of Finaplix-H with a couple of conversion kits. -12 200mg deca amps -20 100mg Primobolan amps -1 50mg/20cc Winny V -100 anavar -Proviron -Triacana and clens -HCG,clomid,nolvadex Will it be safe to use the Deca with another mass steroid for the first part of the cycle then the fina with the Primo/Winny and anavar for the second half? I basically have access to most everything.Can you make any suggestions on what I should do? I have the opportunity to use growth and slin for the first time. Should I even bother with it? If I use the growth I would use 5iu for 2 months.     | ||
|
Amateur Bodybuilder 
Posts: 96 |
Sorry bro am not a vet but do know that your not going to have a very effective cycle gaining mass and trying to cut at the same time. Your body responds to food when on a good amount of gear. Bulk cycle/cut cycle not bulk cycle cut cycle at once. | ||
|
Novice
Posts: 8 |
I am sorry if I wasn't clear but I meant mass cycle then immediately a cutting cycle . | ||
|
Amateur Bodybuilder
Posts: 145 |
I suggest that you use EQ, Primo, deca and fina in the first cycle...fina can only be used for 4-6wks....don't OD on the dosage it's effective....i didn't see results till like after a couple of wks...but they come and they're huge the second cycle should be EQ,Winny,Primo and if you want although they are mainly for strength in sports anavar | ||
|
Novice
Posts: 8 |
LBP thanks for the info. Your help is appreciated. | ||
|
Amateur Bodybuilder
Posts: 126 |
If you can afford Growth then I would go for it big time, you will see what growth is all about. ------------------ |
All times are ET (US) | |
 |
|
|
posted December 03, 2000 10:25 AM