![]() |
![]() |
![]() |
![]() |
![]() |
![]() ![]() ![]() ![]() ![]()
|
Author | Topic: Not a virgin anymore! | ||
Novice ![]() Posts: 1 |
Hey bros, Tonight I did my first shot of my first cycle, and god did I love it. I started out planning to do it in glutes, but I could not turn all the way around to stick myself in the ass, so I ended up going into thigh. I had 22g 1.5 inch, and went in a little ways and felt a twinge (nerve I believe) so I pulled out and went in again, this time I went in about 3/4s of the way or more (is this to far?) no blood etc, so I injected it. Its been about 2 hours since shot, and I have no pain at all in leg where I injected, It was T200 by the way - jus twondering if it is normal to not have any pain, and if not, what happened or whats going on? I did 3 cc's, and am going to do another 2 cc's in a few days, starting out w/ 1 gram of T200 a week (which averages to about 760 I figure?. Just a few quick questions tho, I am also going to do DBol, I have my milk thistle and am going to begin this tomorrow. Question - I have all the clomid I need, enough to go through entire cycle, and another month or two worth after that, do you recommend using clomid EOD throughout cycle, or just at the end? I have heard of some very nasty out breaks of acne while using it, and I do not wish to have this.. also I dont want any mood swings (if this actually does cause it). I have nolva on hand for gyno also, but I just wanted to check with you bro's on those couple things.. kinda had me worried w/ no pain, but maybe im just lucky =). Lucerino ![]() ![]() ![]() ![]() | ||
Elite Bodybuilder ![]() ![]() ![]() Posts: 698 |
Congrats bro on the first poke. I would run the clomid eod the whole way. I've never had mood swings from it. Glad to hear you have clomid and nolva on hand. It's good to see you did the necessary research befor you started. Keep us posted on your gains. ------------------ ![]() ![]() ![]() ![]() |
All times are ET (US) | |
![]() |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c