GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Semi-Cloudy Fina
|
| Author | Topic: Semi-Cloudy Fina | ||
|
Amateur Bodybuilder 
Posts: 102 |
Bro's I made 2 batches of fina-both were nice and clear before I further sterilized them in the oven @ 250 degrees. I put them on a baking sheet and nuked em for 15 minutes, then let them set for 10 minutes. I repeated this process, only the second time, fina came out of one of the vile's I was nuking. I lost a good 8cc worth. Nothing happened to the other vile--it was clear and I lost nothing from it. Now the second vile is not as clear as the first one, although its not substancially unclear. To make sure, I drew out 2cc from each vile into syringes. I checked them over and vial 2's liquid was still slightly darker than vial 1's. Do you bro's think its ok to inject from vial 2? I know it was sterile before I nuked it. I used a coffee filter and sterile filter in the process. Any ideas???    | ||
|
Amateur Bodybuilder
Posts: 102 |
Bump... I would apprieciate any help guys. | ||
|
Elite Bodybuilder 
Posts: 715 |
I'll bump... BTW, did you stick one of the needles in the tops of the vials to relieve pressure as you sterilized them?  | ||
|
Amateur Bodybuilder
Posts: 102 |
Yes I did. Ya know, when I draw the solution into a syringe, its a lot clearer than when its in the bottle. | ||
|
Elite Bodybuilder
Posts: 715 |
well if you made each one separately then they cant be perfectly the same. If the cloudy one was clear before sterilizing it, then there shouldnt be any problem. | ||
|
Amateur Bodybuilder
Posts: 102 |
clemdog- thats what i figured too. the second vial had a lot more glue/fillers left over than the first one so im thinking some of that shit is suspended into the solution and wont come out, although its not much. So i guess ill go ahead and shoot it. |
All times are ET (US) | |
 |
|
|
posted December 02, 2000 05:59 PM