![]() |
![]() |
![]() |
![]() |
![]() |
![]() ![]() ![]() ![]() ![]()
|
Author | Topic: first cycle...hows it look? | ||
Cool Novice ![]() ![]() Posts: 17 |
Sust/week Primo/week D-bol/day week 1- 500 -- 15 week 2- 500 -- 15 week 3- 250 -- 15 week 4- 250 -- 15 week 5- 250 200 -- week 6- 250 200 -- week 7- 250 200 -- week 8- 250 200 --
thanks ![]() ![]() ![]() ![]() | ||
Amateur Bodybuilder ![]() ![]() Posts: 139 |
I would up the sust to 500 throughout..no need for that taper and I would increase the d-bol to at least 30 mg a day. I would also suggest you drop the primo or wait until week 8 to bring it in. How about a little deca in there too...400 a week for the 8 weeks. ![]() ![]() ![]() ![]() | ||
Pro Bodybuilder ![]() ![]() ![]() Posts: 488 |
dont tapper the sust up the dbols and primo. ![]() ![]() ![]() ![]() | ||
Pro Bodybuilder ![]() ![]() ![]() Posts: 543 |
Up the sust to 500 for all weeks. There is no need to taper it. Dbol is very low. 30mg day for four weeks then taper dowm for two more. All the primo is going to do at 200 for four weeks is waste your money. Drop it, you won't need it nor will it benifit you. Up the sust and up the dbol. I know it's your first cycle and you are cautious but you'll be all right. Grow buddy, and use your money on gear wisely. ------------------ ![]() ![]() ![]() ![]() | ||
Cool Novice ![]() ![]() Posts: 47 |
yeah. go with what the bros say. i am in the middle of my first cycle (sus and deca - v.low dose) and am regretting not doing sus 500mg for 8 weeks and deca 400 mg for 8 weeks. up the dbol too. i was being far too cautious. the only side effect that i have had so far is a little acne on my shoulders. learn from my mistakes. good luck ![]() ![]() ![]() ![]() | ||
Moderator ![]() ![]() ![]() ![]() Posts: 1874 |
Go to at least 500mg sust/week. I would say 750 but less than 500 is wasteful. Get the d-bol up to 30mg per week. Have you looked into deca at all? ![]() ![]() ![]() ![]() |
All times are ET (US) | |
![]() |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c