GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 HELP! - Please.
|
| Author | Topic: HELP! - Please. | ||
|
Amateur Bodybuilder 
Posts: 51 |
At the end of my third cycle and i am bridging with 400 primo/wk, i have had a little pain from sus before but no big deal but the fucking pain from the primo is unbearable - it takes 3 tries to inject the full 400, I normaly mix my sus with deca which takes the edge off the pain, but i am shooting primo alone, is there any "cheats" to stop the pain?, i have tried warming the oil up first but that didnt work. CY. P.S. The pain is during the injection not so much afterwards. (injecting Glut)     | ||
|
Pro Bodybuilder 
Posts: 364 |
Try mixing it with B-12... ------------------ | ||
|
Pro Bodybuilder
Posts: 531 |
What guage pin are you using for Primo I usally go with a 22 guage have no problem... and yes it does hurt a little IG | ||
|
Pro Bodybuilder
Posts: 541 |
First of all 400mg of primo a week will not work to bridge. 200mg/week is about all you can do without affecting your natural test levels. I suggest you lower your dosage to keep you balls in gear. Also, if you are using the acetate version of primo....I know the pain. It is pretty fucking shitty but you just got to get used to it. You really need to look into the depot as it was alot better. Also, if this ia acetate your describing then you know you have to shoot every 1-2days don't ya? Had a buddy make that mistake. | ||
|
Moderator 
Posts: 4038 |
I agree that 200mg of Primo per week would be enough to bridge. Also, Primo hurts and there isn't much you can do about it. Try PGF2 for a while and you will laugh at the pain from Primo. If it is really that bad, then take a suggestion stated above and mix it with b-12, (but keep in mind that b-12 is water based) |
All times are ET (US) | |
 |
|
|
posted October 16, 2000 10:47 AM