GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Just started cycle. Major Question
|
| Author | Topic: Just started cycle. Major Question | ||
|
Cool Novice 
Posts: 49 |
Bros I just stuck my self for the start of my cycle. 1st Q I injected 2ccs of sten and when I pulled out quite a bit ran out why? I used 23g pin. 2nd Q I am going to have volumous injections so I am going to have to spread it around besides the ass. How does one do it? I know the basocs but Ive tried the thigh and shoulder before and no sucess. Thanks     | ||
|
Cool Novice
Posts: 13 |
Try the middle side (outside) of your upper leg, quite easy to reach and not painful at all... | ||
|
Amateur Bodybuilder 
Posts: 261 |
Go to 2thicks site. It's all you'll need. ------------------ | ||
|
Amateur Bodybuilder
Posts: 172 |
Can anyone give me 2thicks site. I need some injection info | ||
|
Amateur Bodybuilder
Posts: 96 |
GO TO FEATURED SITES IN THE ELITE FITNESS HOME PAGE AND IT IS RIGHT THERE. HOPE THIS HELPS M18 [This message has been edited by MUSTANG_18 (edited October 14, 2000).] | ||
|
Pro Bodybuilder 
Posts: 388 |
I had the same problem when I was taking sten...right after I pulled out the syringe the shit would dribble down my leg. I was definately injecting it right, but the oil in sten is extremely thin..like water. I found it helped to leave the syringe in for a couple minutes after injecting then pull it out very slowly...then massage the injection site for a few minutes. |
All times are ET (US) | |
 |
|
|
posted October 14, 2000 07:37 PM