GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Making injectible fina, WITHOUT a kit-safely.
|
| Author | Topic: Making injectible fina, WITHOUT a kit-safely. | ||
|
Amateur Bodybuilder 
Posts: 64 |
Being that Animal has been out of stock lately, I was forced to improvise in making my own fina this past week- it's worked great so far, and I managed to save a few bucks in the process. (not a mishap like my winstrol incident,for those who remember). This is what I did: Emptied out an oral anaesthetic bottle, cleansed with 100% isopropyl alchohol. Crushed fina pellets, and filled bottle with 10ml of soybean oil. Added powder from 30 pellets (600mg TA). Brought water to a boil in a cooking pot, water level about 1in. deep, turned off heat, immersed bottle in hot water bath after boiling ceased with the cap losely on (waterline was a few mm below the lip of the bottle cap-DO NOT close the cap completely unless you want the bottle to crack/explode!) and put the pot lid on. Pellets dissolved for the most part, with crud/sludge gathering at the bottom. I removed the bottle(while the water was still hot, but cool enough to not burn my hand), tightened cap, shook, let sit until water was lukewarm, then removed bottle, brought to boil again and repeated. After this had been done, as a precaution (the heat most likely eliminated any bacteria/viruses, but I can be a paranoid SOB when it comes to infection after my abcess), added .5ml ethanol (if you use ethanol, make sure it is NOT denatured!) and shook. After an hour the contents had settled with the crud/sludge at the bottom (glue/binders), with the clear oil TA solution at the top, ready to draw. I've been taking 100mg ever day now for the past 5 days, and I think I'll make another batch =) Enjoy.    | ||
|
Novice 
Posts: 4 |
I would like to hear some opinions on this one! | ||
|
Pro Bodybuilder 
Posts: 358 |
I think that some of that "crud" at the bottom of the bottle is tren. You tried to make a 60mg/ml solution using only oil as the solvent. Tren acetate is poorly soluble in oil, maybe 10-20mg/ml will dissolve. I tried to make it with extracted tren acetate (removed as much of the fillers and binders as possible before dissolving in oil) and could not get it to dissolve without the addition of ethanol and propylene glycol. Add some more ethanol to ensure a higher concentration. | ||
|
Pro Bodybuilder
Posts: 509 |
I have used sort of the same method about 6-10 bottles worth. I have never had a problem.  | ||
|
Cool Novice 
Posts: 14 |
Dude where do you get fina anyway help me! I purchased some once but my source is gone now. | ||
|
Cool Novice
Posts: 14 |
quote: |
All times are ET (US) | |
 |
|
|
posted October 03, 2000 09:12 PM