GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 WHAT IS THE LARGEST PIN SIZE?
|
| Author | Topic: WHAT IS THE LARGEST PIN SIZE? | ||
|
Pro Bodybuilder 
Posts: 590 |
I HAVE HEARD OF AN 18G, ANY PINS LARGER THAN THAT?     | ||
|
Amateur Bodybuilder 
Posts: 184 |
18g i use for drawing out the juice. i use a 21g for injections..people call me crazy but i havent had any problems with it. i am going to use a 23g from now on as a test. | ||
|
Amateur Bodybuilder
Posts: 273 |
i stick with 22 or 23 guage myself. don't have a problem using anything. i won't go trying 18 guage needles for injecting, does anyone remember the 18 guage that used to come with the sostenon preloads from mexico. i haven't used them in a few years but damn they were nasty. ------------------ Email me if you have any questions | ||
|
Amateur Bodybuilder
Posts: 87 |
dude it goes all the way down to a 12 guage but holy shit bat man, try that | ||
|
Amateur Bodybuilder
Posts: 129 |
I've seen 10g pins in the ER. They use them to do chest decompressions. That's a big flippin' pin. You might as well shove a flagpole in your ass, LOL. WW | ||
|
Amateur Bodybuilder
Posts: 74 |
For my first cycle I used 16g in the glute. This was many years ago and I didn't know a sixteenth of what I do know. | ||
|
Moderator 
Posts: 2626 |
I'm with you wondertest, my first cycle, many years ago, I jacked EQ in my fathers barn with his horse pins...14ga. I cried...you could see daylight all the way through that fucker!!!!! Never again!!!!!!!! | ||
|
Amateur Bodybuilder
Posts: 74 |
I saved the boxers I was wearing that day for years, looked like male PMS. I tried explaining the size to my wife cause she was bitchin about using a 22g for her primo (I ran out of 25's). I told her you can fit a 22 inside a 21 and they get bigger exponetially!!! | ||
|
Amateur Bodybuilder
Posts: 67 |
personally i use 20ga. pins but i buy then at the local farm store and i don't mind a little bit of pain!! Believe me where i work at i have seen pins 16 ga at least 12 inches long so a 1.5 20 ga. ain't shit!! [This message has been edited by Director (edited September 30, 2000).] | ||
|
Elite Bodybuilder 
Posts: 965 |
14 gauge, my god, Ranger, how could you do that ? ------------------ Don't look back, life is too short | ||
|
Amateur Bodybuilder
Posts: 175 |
I did it w/ a 2 ga once!!!! Never again!!! OUCHHHHH!! |
All times are ET (US) | |
 |
|
|
posted September 29, 2000 08:58 PM