GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 any way i can make this lump go down/away quicker?
|
| Author | Topic: any way i can make this lump go down/away quicker? | ||
|
Elite Bodybuilder 
Posts: 628 |
you should know the story by now, i hit 200mg prop and 150mg of cut fuel yesterday w/ an inch pin(i know, i know)now my ass is as tender as can be, anyway to get this lump down besides time---im hurting here fellas?  ------------------     | ||
|
Amateur Bodybuilder 
Posts: 228 |
how about getting a electric hand massager..i dont know if that will agitate the area or disperse the oil..i will bump it for my hurting bro! ------------------ knowledge = power | ||
|
Amateur Bodybuilder
Posts: 160 |
I always used a heating pad, and rub the spot of injection for a min. or two. That always help me... | ||
|
Amateur Bodybuilder
Posts: 252 |
go jogging... | ||
|
Amateur Bodybuilder
Posts: 171 |
Try using an ice cube. The next time you inject try icing the area and then inject. It numbs the area and doesnt hurt at all and no blood. | ||
|
Amateur Bodybuilder
Posts: 169 |
I use a microwavable hot compress that I bought at Rite Aide. It works wonders. Once the area has been "cooking" massage it. It is oil in the muscle, and I seriously doubt that an icecube would help to thin the oil or loosen up the muscle tissue.  | ||
|
Amateur Bodybuilder
Posts: 137 |
gO JOGGING OR TAKE A WARM BATH | ||
|
Amateur Bodybuilder
Posts: 51 |
Bro, Try a couple of hot compress's i take it you know what they are. But for the newbie's Get a towel and get a bowl of hot water and soak the towel in it. then take the excess water off the towel and apply the towel to the affected area and apply pressure. repeat this up to 5 time's with a massage in between each compress. this will help disperse the oil it should go after about 4 times. if it does not go and is hard you could have a problem go and see a doc. Sorry bro but i expect i would have got a mail asking me what a hot compress was if i did not say. ------------------ | ||
|
Novice 
Posts: 9 |
I get a heat pad and warm up the lump. Than I get my girl to rub it out for me. That way you don't stop cause it hurts, you just let her rub it cause you don't wanna look like a bitch. | ||
|
Elite Bodybuilder
Posts: 628 |
im gonna hit the heating pad right now, cause that mutha fucker is hurting--lump is kinda of hard too. ------------------ | ||
|
Elite Bodybuilder
Posts: 1197 |
I usually have IG massage it really hard with the butt of his palm.....usually helps it to go down....or ends up giving me a nasty bruise.... | ||
|
Amateur Bodybuilder
Posts: 93 |
My mother is a nurse. When I told her about the lumps on my ass, she told me that warm, not hot, compresses with a rag would make them go away. It worked good for me. ------------------ | ||
|
Amateur Bodybuilder
Posts: 181 |
go jogging, then get a heating pad, then get your girl to give your ass a nice massage. | ||
|
Cool Novice 
Posts: 39 |
HOT PAD, HOT TUB AND MASSAGE... INJECT DEEPER BRO!! | ||
|
Amateur Bodybuilder
Posts: 87 |
remember first, make sure its not infected (which im sure its not, too soon) then if its blood only time will cure it, i get mine from the oil in the muscle, i strech through out the night and massage and warm compresses and by 2 days its not hurting anymore. Hope it helps. | ||
|
Elite Bodybuilder
Posts: 1117 |
good advice ------------------ | ||
|
Pro Bodybuilder 
Posts: 567 |
Couldnt add a thing to the above. Just a suggestion, if the pin seems to push back after you insert and inject a little, your in a dense area where you might have a lot of scar tissue. I get a lump in these areas so usually will move the pin and then almost never have the problem. I shoot glutes only. | ||
|
Elite Bodybuilder
Posts: 628 |
thanks fellas, appreciate all the info. ------------------ |
All times are ET (US) | |
 |
|
|
posted September 28, 2000 09:33 PM
