GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 First shot this morning...help me out bros.
|
| Author | Topic: First shot this morning...help me out bros. | ||
|
Cool Novice 
Posts: 21 |
I did it. I woke up and took my first shot this morning (Nor200). I want to be sure my technique is on point. I pulled back the plunger and inserted the needle into the vial. Next I held the vial upside down and pushed the air into the vial. I pulled back and drew up the Nor200. Should I draw back so the liquid is at the desired cc mark or the black piece at the front of the plunger??? Anyway after 3 sticks I inserted the needle in with no pain. It seemed very easy to inject...is this normal??? Finally I cleaned myself up and stuffed my face at the dining hall. Please let me know if I am using the correct technique...Thanks.    | ||
|
Pro Bodybuilder 
Posts: 491 |
I always change needles after I draw from the vial. It will dull the needle and make harder to insert. But you didn't d\seem to have a problem with that. I don't understand your other question....You need the liquid to be at the desires cc mark. The black piece should be just below it. Are you stacking the deca with anything? D. | ||
|
Cool Novice
Posts: 31 |
sounds like a good first shot. if bleeding becomes a problem at all, make sure you draw back on the needle after it is inserted into your glute/quad, to make sure you arent hitting any veins. other than that, best of luck with your gear.  | ||
|
Elite Bodybuilder 
Posts: 700 |
Dylan I do the same. Pins are cheap! | ||
|
Cool Novice
Posts: 38 |
The rubber stopper on the vial doe's NOT dull the needle. I can't for the life of me wonder why people think that. When was the last time you had a shot at the doctor's office and saw them change the pin after drawing in medicine. It's just a waste of time and not necessary.......... | ||
|
Amateur Bodybuilder 
Posts: 293 |
Hey bro, did you buy the pins @ Wal-Mart or from 2Thick's page or what?? Looking for the easiest/best deal...drop me an e-mail... ------------------  | ||
|
Elite Bodybuilder
Posts: 824 |
If you could use the same needle for drawing and shooting, well your needle was TOO tick. ------------------ Don't look back, life is too short | ||
|
Amateur Bodybuilder
Posts: 174 |
The reason the nurse doesn't change needles when you are in the Dr. office is because the motherfucker is not going in her!!! Like she gives a shit if it is dull or not. Duh!!!! | ||
|
Amateur Bodybuilder
Posts: 54 |
Hey bro. Check out 2thicks injection website its got everytheing you need to know. It sounds like your pretty safe though. Might wanna change the tip after drawing your juice. Be sure to clean the rubber seal on the vile and the injection site. I even go over the needle shaft with alchohol.. |
All times are ET (US) | |
 |
|
|
posted September 11, 2000 11:47 AM