GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Injection Knowlege
|
| Author | Topic: Injection Knowlege | ||
|
Cool Novice 
Posts: 18 |
What are the smallest 1.5 pins that can be used to inject Deca/Primo/Sust? How warm can I make the gear prior to injection and what is the process? How long should I take to inject 2-3 cc of gear? ------------------    | ||
|
Elite Bodybuilder 
Posts: 685 |
25 gauge pins work just fine. I run my loaded pins under the hot water in the bathroom, with the caps on ofcourse. It takes me about 2 minutes to inject 3cc's into a glute. I haven't really timed it, so I won't swear to that 2 minutes, but not long in any case.  | ||
|
Cool Novice
Posts: 18 |
Thanks Ice Man That is exactly what I needed to know. DSPO ------------------ | ||
|
Novice 
Posts: 4 |
That has to raise the temperature of the solution greater than the manufacturers suggested storage temperature (see box and insert for details) . I wonder how much loss of efficacy there is doing this? I dont see why one just doesnt get convention 22 or 23 gauge pins. I wouldnt take the risk of losing some efficacy to go this route. ------------------ | ||
|
Cool Novice
Posts: 40 |
Iceman, Conventional wisdom from the brothers seems to be 23g x 1.5" (in general) in the glutes. Just curious, what prompted you to go with your choice of pin? Later, | ||
|
Amateur Bodybuilder 
Posts: 297 |
I think 22-23g ,1 1/2" is finefor the oil based stuff ( though ive been using 1/2 28g to whack my tris with Prop 50mg/ml ) , the greater the volume of the injection and the higher the concentration of ingredient the deeper i bury it into the muscle . Ive found that i dont get all that soreness or a large lump that is noticable with a high volume injection when i do this . As far as warming the injection , i just run warm water over the barrel ( i leave the point capped ). |
All times are ET (US) | |
 |
|
|
posted August 29, 2000 11:54 AM