disolve one finaplix box(10 implants/100 yelow pellets)into 5-10 ml of acetone or methanol which ewer is awailable, let sit for no longer than one hour.

add 50 ml of sesamy oil gently let sit untill further dissolved aprox. 2 hours

warm up by letting sit in hot water

gently swearl till cloudy yellow/orange further disolving rest of solution let sit in the hot water as it cools it will seperate

run it thru a cofee filter first let the top of the solution go then pour in the rest you can repeat this

put a needle in a sterile botle top then filer solution with seringe filter take filter out atach to siringi in sterile botle draw out and repeat until all gone

you can adjust the mg/ml by incorporating the amounts of the acetone

------------------
Jeff

Don't look back, life is too short

Email PLEASE DON'T POST SOURCES and ask for his list.

I'll be ordering my kit monday so if you'll want to wait and see if all goes well. But I am sure that this guy is on the straight up. you can get more info on fina at www.renegadebodybuild.com

1.desolved 2 finaplix in 15 ml of acetone

2.with in an hour i aded 80ml of oil

3.let sit overnight to let separate

4.boiled pot of hot water when it reached boiling point i turned it of added the vial of tren(i set the vial in) and let it sit untill it reached room temperature.

5.then i filtered thru a cofee filter twice

Crush up 4 pellets in a mortar and pestel, add 3/4cc dmso mix until liquid, add couple drops benzyl alcohol, then take the pin off a 23G or so, and draw up the liquid, put the pin BACK on, and shoot it through, do this until is shoots out w/ no clogging or problems, i do it like 3 times. then shoot it and say you shot 80mg, not 76 (which is probably half THAT after all your filtering) i've used a*****@skuz's kits but this works better.
some of my friends heat this mix in the microwave for 15 seconds before adding the alcohol, but i know heat CAN act as a catalyst, so i don't want to change the structure of my fina.

if i'm having a busy semester at med school, and don't have time to mix up shots EOD, i do THIS:
(those concerned w/ sterility may like this better)
crush a WHOLE cart, add 5cc dmso mix until dissolved, then add this to a vial filled w/ 15cc's of EMU oil (i use emu oil for many many reasons, to name a few, it's an anti-inflammatory and it's bacteriostatic) then i add about 1/2cc of benzyl alcohol. this gives you a 100mg/mL solution, that is relatively sterile. (i know at least 10 peeps, that ONLY use this concoction and no other juice) and unlike me and all the shit i use, NONE of them ever had an absess or fever or any adverse effects from this concoction. spend the 25+ bux and FOUR+ hours w/ the kit if you want, i've used every method, from snorting, swallowing, sublingual, dmso, phlojel, emu-oil+dmso, and this way is the ONLY method that i KNOW gets me EVERY last MG.

oh well, let the flames begin...
just trying to help.

hope this helps....

the more you know...
the more you'll GROW!!!

B) is it safe to inject dmso?
Yes, your body makes a certain amount of DiMethylSulfOxide and it, unlike, acetone, propanol, benzene, and many other solvents has never shown to be carcinogenic or harmful even at HUGE IV doses.
In fact one of only TWO FDA approved uses for DMSO (in the States) is for Cystitis and pt's are given 100's of times more DMSO, IV.
W/ NO adverse reactions.

hope this helps.