GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 ?????????
 component t-h injections small or large pins
|
| Author | Topic: component t-h injections small or large pins |
|
Kid Lightin Amateur Bodybuilder (Total posts: 43) |
posted August 14, 2000 03:19 PM
  
I need to know if I can use a regular allergy shot needle to inject component t-h. Should I use the offical 23g 1.5 sticks. How many cc's is 75mg. [This message has been edited by Kid Lightin (edited August 14, 2000).] IP: Logged |
|
ripped to shreads2 Pro Bodybuilder (Total posts: 247) |
posted August 14, 2000 03:23 PM
1 ml equals to 1cc IP: Logged |
|
aahepp Pro Bodybuilder (Total posts: 401) |
posted August 14, 2000 03:48 PM
The allegery needle would be as little to small. The standard pin would be better. If you did the conversion then 75mg=1cc. That is the standard conversion from the kit. The does have some +/- depending on the way you made it. IP: Logged |
|
Kid Lightin Amateur Bodybuilder (Total posts: 43) |
posted August 14, 2000 04:29 PM
Hey Bros. thanks for the info. IP: Logged |
|
MarkM Amateur Bodybuilder (Total posts: 27) |
posted August 14, 2000 05:20 PM
I use 25guage 5/8" pins for fina. I'm lean so if you depress the pin into the skin an extra quarter inch or so it gets in deep enough. I prefer the smaller pin since I like to inject everyday due to the very short half life of the fina. IP: Logged |
All times are ET (US) | |
 |
|
|