GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Friends 2nd shot of Sust
|
| Author | Topic: Friends 2nd shot of Sust |
|
thefantom1 Amateur Bodybuilder (Total posts: 46) |
posted August 05, 2000 12:52 AM
  
Well my "friend" just did his second shot of sust in the other quad a few minutes ago... This one was more akward but so far not as painful. He didn't put the needle in all the way..left about a quarter inch out this time. (sust redijects) it took longer to inject as he wanted to go slower so as not to be so painful later on. The pain in his right leg just subsided today from his first shot on Monday. This time there is no feeling of freaking out like his first shot. He did notice that since monday he has been hornier then hell and of course at this time he is single... I sure hope this stuff doesn't make his "good arm" a lot bigger than the other arm. ;-) He wants to thank all the bro's for the suppport and knowledge... Peace.. IP: Logged |
|
rocksolid23 Amateur Bodybuilder (Total posts: 9) |
posted August 05, 2000 02:07 AM
Hope he is not using the pre-packaged needle, too big. Peace IP: Logged |
|
CornFed Pro Bodybuilder (Total posts: 279) |
posted August 05, 2000 03:53 AM
God damn. Inch and a half needles hurt my quads worse than anything. See if he can replace them with 1/2 inch it's way easier and hurts less.. IP: Logged |
|
CornFed Pro Bodybuilder (Total posts: 279) |
posted August 05, 2000 03:53 AM
God damn. Inch and a half needles hurt my quads worse than anything. See if he can replace them with 1/2 inch it's way easier and hurts less.. IP: Logged |
|
Bubba Amateur Bodybuilder (Total posts: 49) |
posted August 05, 2000 04:13 AM
You should be going an inch deep on a quad shot. 1/2 inch maybe in the shoulder or tri's. IP: Logged |
|
aahepp Pro Bodybuilder (Total posts: 313) |
posted August 05, 2000 07:19 AM
1/2 pins is alright for the quads, depending on the amount of fat you have covering the muscle. 1" will work if you have big quads. 1 1/2 is just way to big because you might come out the other side of the muscle. IP: Logged |
|
thefantom1 Amateur Bodybuilder (Total posts: 46) |
posted August 05, 2000 11:22 AM
The pins (rediject) my "friend" used last night where 1 1/2. He went in only about an inch this time as compared to all the way the first time. His leg is not nearly as sore as it was the first time. IP: Logged |
|
BigWh1tey Pro Bodybuilder (Total posts: 232) |
posted August 05, 2000 11:29 AM
Fuck i hope your friend knows to place the sost in a smaller gauge syringe before injecting . lest he suffer a wound from the mighty mexican harpoon . IP: Logged |
|
Maverik Pro Bodybuilder (Total posts: 496) |
posted August 05, 2000 11:18 PM
If you went all the way in with a 1 1/2 needle on the first time then that is why it is hurting so bad. I figured that was what you did but you never said. Get some smaller needles next time fantom. Peace...Mav IP: Logged |
|
Bam Bam Amateur Bodybuilder (Total posts: 9) |
posted August 06, 2000 11:15 AM
The sos pin is probably a 20 g. needle. get a 1/2 inch 23 or 22 g. take off the needle and then transfer the juice from the big pin to the 22 or 23 g. pin... IP: Logged |
All times are ET (US) | |
 |
|
|