GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 What size pins do I use with Primo?
|
| Author | Topic: What size pins do I use with Primo? |
|
loomisH Amateur Bodybuilder (Total posts: 96) |
posted August 01, 2000 09:03 AM
  
I'm assuming because it is suspended in water that I can use smaller pins than I would for deca or sus. What size do you bros use for primo? IP: Logged |
|
aahepp Pro Bodybuilder (Total posts: 279) |
posted August 01, 2000 09:09 AM
Since your using a water based injectable, if that's what it is, then you can go with a 27 or 25g. And of course the length depends on where you are going to inject. [This message has been edited by aahepp (edited August 01, 2000).] IP: Logged |
|
Ice Man Pro Bodybuilder (Total posts: 641) |
posted August 01, 2000 09:18 AM
Primo is oil based. 25 gauge works fine and is about as small as I would go. IP: Logged |
|
ThePitbull Pro Bodybuilder (Total posts: 612) |
posted August 01, 2000 09:21 AM
Primo is not water based, it is oil based. ------------------ IP: Logged |
|
5setsofsix Pro Bodybuilder (Total posts: 99) |
posted August 01, 2000 11:26 AM
Primo is oil based. I use a 23 guage 1 1/2 spear. I believe a 1 inch will work just as well. Don't worry about the size bro. 23 ga goes in easy. We are talking glute injections. I just wanted to clear that up. [This message has been edited by 5setsofsix (edited August 01, 2000).] IP: Logged |
|
LEGEND Pro Bodybuilder (Total posts: 231) |
posted August 01, 2000 05:30 PM
23 for the glutes and 25 for the quad or delt, no bigger then 1" for the quad and delt ------------------ IP: Logged |
All times are ET (US) | |
 |
|
|