GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 breaking sus vials
|
| Author | Topic: breaking sus vials |
|
therealj Amateur Bodybuilder (Total posts: 48) |
posted July 28, 2000 02:57 PM
  
I am about to start my first cycle...just curious if there is a good link for the proper way to open those bad boys and load them in the syringe....should I use a lower gauge to draw the sust up and then a higher gauge to inject...I have 22g right now..thanks for helping with my often asked question IP: Logged |
|
Vitaman Pro Bodybuilder (Total posts: 496) |
posted July 28, 2000 03:04 PM
I just put the Sust amps in a small towel and pop them open. I use 22 guage to suck it up and to stick with. ------------------ IP: Logged |
|
goleafs Pro Bodybuilder (Total posts: 776) |
posted July 28, 2000 03:14 PM
file down one side , you dont need to file clean through , more like scoring it. i put it in a pen top and pop of the top with a spoon handle or something then just draw it into a syringe. next ram that bab boy in yer glute and go for a workout , go to sleep - have crazy dreams. wake up - repeat. IP: Logged |
|
Bubba Amateur Bodybuilder (Total posts: 35) |
posted July 28, 2000 03:16 PM
I have Omni from Jelfa. I just hold em' tight in my hand and pop the top with my thumb. I draw the oil up with one 22g pin, switch ends, then inject with a fresh one. I use the same drawing point about five times then I get a fresh one. IP: Logged |
|
TPH Amateur Bodybuilder (Total posts: 4) |
posted July 28, 2000 03:18 PM
You may need to file down the amps. Go to Home Depot and get one of those metal files, their cheap and they'll last. They are alot easier to use than regular emory boards IP: Logged |
|
ajc1977 Pro Bodybuilder (Total posts: 684) |
posted July 28, 2000 03:28 PM
Use a file to score the neck of the amp and then hold it with a paper towel when you snap it off. ------------------ IP: Logged |
|
therealj Amateur Bodybuilder (Total posts: 48) |
posted July 28, 2000 03:50 PM
thanks boys!! IP: Logged |
|
morereps Pro Bodybuilder (Total posts: 327) |
posted July 28, 2000 03:55 PM
Your other question was about using a thinner needle to shoot. Yes I use a 22g to draw and switch to a 25g to shoot it comes out a little slow but I cant even feel the needle. Good luck ------------------ IP: Logged |
|
slabcat Pro Bodybuilder (Total posts: 437) |
posted July 28, 2000 04:19 PM
You can go to a pharmacy or a medical supply store and buy an ampule opener. They're only four bucks. If not just stick a pen cap on top and snap it off. Piece of cake bro. Good luck. ------------------ IP: Logged |
|
daveyboy Amateur Bodybuilder (Total posts: 96) |
posted July 28, 2000 05:54 PM
alot of people use a file or knife to score the amp around the neck (breaking point) then snap them. i just use a knife when i score the amps, i have never tried an amp opener but i would guess that would be the easiest. some amps don't need to be scored but other do, just depend how thick the glass is. as for needles the 22 guage will work fine for both drawing the fluid (oil or water) out and for injecting. you can switch needles if you like but 22 or 23 guage is not that bad in inject with. the old sostenon preloads used to come with an 18 guage needle! ------------------ Email me if you have any questions IP: Logged |
|
Gettinhard Pro Bodybuilder (Total posts: 127) |
posted July 28, 2000 06:04 PM
Bro, save yourself from breaking the amp and fucking it up...goto this web site and search for ampule opener they are 4.20 each and will arrive in 3 to 5 days.... IP: Logged |
All times are ET (US) | |
 |
|
|