GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Will these work?
|
| Author | Topic: Will these work? |
|
oubeta Amateur Bodybuilder (Total posts: 95) |
posted July 24, 2000 12:40 PM
  
I was getting ready to order some darts from 2thick, but I was at WollyWorld today and they have 23ga one inch 3cc pins. Are these to short for glute injections? They are also .25 each..I was going to start my cycle today, but they were out of 1.5 inchers..Thanks bro's ------------------ IP: Logged |
|
Juice Junkie Amateur Bodybuilder (Total posts: 17) |
posted July 24, 2000 12:54 PM
I don't think this would be to bad. I use nothing but 1" and have never had a problem. Try it if oil comes out after you inject then it wasn't deep enough. Also try a local feed store most have 22ga. 1-1/2" readily available with no questions asked. They are individually wrapped either in plastic or a plastic case and are sterile. Another thing is if oil does come out in your ass try it in your leg where the fat and skin is thinner. (outer portion midway up your quad) JJ IP: Logged |
|
Jeff_rys Pro Bodybuilder (Total posts: 515) |
posted July 24, 2000 03:36 PM
one inch should do it for must of us. Just go high enough in the glute. ------------------ Don't look back, life is too short IP: Logged |
|
pillboy Pro Bodybuilder (Total posts: 172) |
posted July 24, 2000 03:38 PM
go ahead and start the cycle today and use the 1 1/2 darts. Just dont push all the way in. Ive used them before and had no problem. .25 is about the norm for dart prices. IP: Logged |
All times are ET (US) | |
 |
|
|