GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Are these pins good enough?
|
| Author | Topic: Are these pins good enough? |
|
Daeo Amateur Bodybuilder (Total posts: 20) |
posted July 21, 2000 11:03 AM
  
I currently have 3/4 inch 22 ga needles and plan on injecting deca and primo. Was wondering if these were good enough or if I should get some 1 1/2's. My girlfriend is also injecting primo with these. How do you know if you're going deep enough? Daeo IP: Logged |
|
rocky Pro Bodybuilder (Total posts: 374) |
posted July 21, 2000 11:09 AM
If you're injecting in your ass get 1 1/2" pins. 3/4 might be OK for delts IP: Logged |
|
jdismukes Pro Bodybuilder (Total posts: 296) |
posted July 21, 2000 11:15 AM
bump that you need to make sure the injection goes into the muscle and not in between the skin and muscle. Check 2thicks injection site. It will give you all you need to know. IP: Logged |
|
hayesjones Amateur Bodybuilder (Total posts: 18) |
posted July 21, 2000 11:16 AM
it really depends on how fat your ass is, seriously. I usually have no problem with 3/4 in my rear because I get it in the upperbutt or close to the hip. If you are that paranoid the go for the 1.5 IP: Logged |
|
aahthit Pro Bodybuilder (Total posts: 260) |
posted July 21, 2000 11:31 AM
Bro, 1 1/2 is the way to go. Quote from any box of any injectible : " for deep muscular injection," not "subdermal injection." Get some 1 1/2's. The deeper you get the better the absorption will be. IP: Logged |
All times are ET (US) | |
 |
|
|