GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 How the f@#$ do I open these amps?
|
| Author | Topic: How the f@#$ do I open these amps? |
|
whodaman Pro Bodybuilder (Total posts: 122) |
posted July 10, 2000 03:26 PM
  
I just got some glass primotest amps in the mail and I don't have an amp opener....Any suggestions? I don't really want to fuck with the shit with-out knowing. During my last Winstrol cycle I tried opening up my last vial the thing shattered and cut my hand open....I wasn't really worried about all the blood, but I waisted my last amp!! Any help would be appreciated...thanks brothers.. IP: Logged |
|
Fish Pro Bodybuilder (Total posts: 570) |
posted July 10, 2000 03:28 PM
you file were it is suppose to break, then you just snap it. It is very easy to do once there is a file mark there. Be careful my primo amps are very thin. So I have to file light or it just shoots right through. My Sus is much thicker, so it takes some force to file. Good luck. ------------------ "Obsession is passion. Use it. Make it your strength." -by Puc IP: Logged |
|
ajc1977 Pro Bodybuilder (Total posts: 321) |
posted July 10, 2000 03:30 PM
Take a small file and file away at the neck of the amp so it breaks easier. If theres a colored band on the neck, just file the colored band off. When you go to break it, wrap a clean rag or thick layer of paper towels around the neck to pad it so the top part of the amp doesn't shatter. IP: Logged |
|
anibolism Pro Bodybuilder (Total posts: 106) |
posted July 10, 2000 03:43 PM
I always file them abit and then use a small towel to hold them with when you snap off the top... IP: Logged |
|
whodaman Pro Bodybuilder (Total posts: 122) |
posted July 10, 2000 03:46 PM
Thanks brothers...I'm running to find a file right now!! IP: Logged |
|
Ice Man Pro Bodybuilder (Total posts: 469) |
posted July 10, 2000 03:56 PM
Yes, do file them around the smallest area in the neck of the amp. But the trick I use to pop the top is to... In one hand hold the amp with a rag wrapped around it, so if it does break it doesn't cut you. Next, take the top off a Bic pen, slip it over the end and snap it right off. Very clean every time. IP: Logged |
|
COnCReTE_MAsS Amateur Bodybuilder (Total posts: 18) |
posted July 10, 2000 03:56 PM
just wear gloves and wreck its neck ! ------------------ IP: Logged |
|
anibolism Pro Bodybuilder (Total posts: 106) |
posted July 10, 2000 03:58 PM
Great idea about the pen top.I guess I learn something new each day here.I love this board!!! IP: Logged |
|
anibolism Pro Bodybuilder (Total posts: 106) |
posted July 10, 2000 03:58 PM
Great idea about the pen top.I guess I learn something new each day here.I love this board!!! IP: Logged |
|
Lqdmscle Pro Bodybuilder (Total posts: 152) |
posted July 10, 2000 04:09 PM
Wrap 2 squares of toilet paper around it. One hand hold the bottom and snap off with the other. Snap it quick, it'll be an even break. IP: Logged |
|
YellowD98 Pro Bodybuilder (Total posts: 164) |
posted July 10, 2000 04:11 PM
throw it on the floor or against a wall IP: Logged |
|
whodaman Pro Bodybuilder (Total posts: 122) |
posted July 10, 2000 04:13 PM
That idea about the pen top is great...You guys are the best! IP: Logged |
|
krzysiu013 Pro Bodybuilder (Total posts: 308) |
posted July 10, 2000 05:09 PM
2thick had an awesome pic up a couple weeks ago. chris ------------------ IP: Logged |
|
HeavyLifterX Pro Bodybuilder (Total posts: 257) |
posted July 10, 2000 05:21 PM
Just eat the whole damn thing. ------------------ Work With Your Back And With Your Brain IP: Logged |
|
LEGEND Pro Bodybuilder (Total posts: 160) |
posted July 10, 2000 06:05 PM
i file them lightly and then i put a small piece of scotch tape around the neck, if it shatters the tape holds all the small pieces of glass, better then steping on them later. ------------------ IP: Logged |
|
Heemaan445 Pro Bodybuilder (Total posts: 303) |
posted July 13, 2000 12:06 AM
I put the body of the amp in a .44cal shell casing.....file the neck, then break, that way if its not clean, at least the bottom doesnt crush... and yes, if you can get steroids, I'm sure you can find a way to get a .44 shell casing.... IP: Logged |
|
vdevil Pro Bodybuilder (Total posts: 856) |
posted July 13, 2000 12:09 AM
www.neoforma.com Get yourself an amp opener friend. It is worth the 4 dollars it cost. If you are going to do a.s for a while, get it. IP: Logged |
|
Heemaan445 Pro Bodybuilder (Total posts: 303) |
posted July 13, 2000 12:18 AM
neoforma sent me one for free, damn thing broke, the little metal blade fell out..!?! IP: Logged |
|
roadruler Pro Bodybuilder (Total posts: 174) |
posted July 13, 2000 12:38 AM
I hold the bottom part with my index finger and thumb with my left hand, then with my right hand I put my thumb on the front upper part and my index on the back upper part and just snap it back towards your body, never had a problem yet and I never use a filer. Your left hand palm should be facing towards the right and the left hand palm should be facing down. Its hard to explain but easy to do. IP: Logged |
|
Bchemist Amateur Bodybuilder (Total posts: 10) |
posted July 13, 2000 12:44 AM
I started by using a file, but stopped when I saw how much glass dust it was creating and realized how much scar tissue might form if I got the dust in there by mistake (your body will create a cystic growth around foreign particles as a defence). So instead of a file, I used scissors to score a clean groove around the neck of my amps...wiped the necks...and snapped them off using a towel. Very clean and have never broken one. IP: Logged |
All times are ET (US) | |
 |
|
|