GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 microwave heating
|
| Author | Topic: microwave heating |
|
joe smith Amateur Bodybuilder (Total posts: 36) |
posted June 07, 2000 05:16 PM
  
How long do you guys heat up your juice on average in the mircowave? Also, will 25 by 1" pins be deep enough for 3-5 cc`s of juice per injection if I have low bodyfat in glute area, as I cannot find 25 by 1 1/2 pins! IP: Logged |
|
GEERHED Pro Bodybuilder (Total posts: 127) |
posted June 07, 2000 05:23 PM
Don't microwave. Run it under hot water for a minute. ------------------ IP: Logged |
|
Old Guy Amateur Bodybuilder (Total posts: 8) |
posted June 07, 2000 05:25 PM
Do not heat in the Microwave! Just place the vial in some warm water. Microwaves can alter the molecular structure of the both oil and gear. Is life worth living? Depends on the liver. IP: Logged |
|
delts Pro Bodybuilder (Total posts: 245) |
posted June 07, 2000 06:55 PM
I just draw my shit up w/18g, then pitch the needle, then hold the syringe under warm running water for a minute. Then put my 22g 1.5" on and shoot. Using the microwave has been suggested but I think that's a little hokie. delts ------------------ IP: Logged |
|
SSMAN Pro Bodybuilder (Total posts: 500) |
posted June 07, 2000 07:02 PM
You can use a microwave, but due to varying wattages I wouldn't post any suggested times. Use short time intervals....you can always put it in longer. You'll dial in on the time.....but don't overheat. Also, don't forget to remove the pin prior to nuking. I put my loaded syringe near a light bulb for a few minutes and it's ready to go. IP: Logged |
|
krzysiu013 Pro Bodybuilder (Total posts: 152) |
posted June 07, 2000 07:14 PM
yeah dont microwave. it heats food by exciting the molecules. dont wanna disturb anything, use some warm H20... chris ------------------ IP: Logged |
|
joe smith Amateur Bodybuilder (Total posts: 36) |
posted June 08, 2000 12:07 AM
thanks a lot bro`s! So just take a loaded syringe, b/c my sust 250 is already preloaded, and hold it under warm or hot running water for how long(about 15 seconds or so)until it heats up and then inject?Is that it? IP: Logged |
|
pillboy Amateur Bodybuilder (Total posts: 52) |
posted June 08, 2000 11:58 AM
Yes 1inch is long enough. Running it under hot water is for pussies, so what if it saves you a second or two. Just shoot the shit and limp like hell for a few days. IP: Logged |
All times are ET (US) | |
 |
|
|