GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 question on amp
|
| Author | Topic: question on amp |
|
jarabbit Amateur Bodybuilder (Total posts: 18) |
posted June 06, 2000 05:35 PM
  
Took the top part of the amp off and the substance was somewhat still in the top part, about 30% I would say. This has never happened before, they are 100mg primos. Had to stick the needle in both parts to get the juice. Is this normal? IP: Logged |
|
mrjeremy Amateur Bodybuilder (Total posts: 46) |
posted June 06, 2000 06:09 PM
yeah just make sure to give the top a light flick or tap the bottom on a hard surface. its liquid it has a mind of its own you know. IP: Logged |
|
matty Pro Bodybuilder (Total posts: 795) |
posted June 06, 2000 08:21 PM
just grab the amp by the top, a shake it like you would a thermometer to get the mercury down.....ya know????? it will all go into the bottom easily. ------------------ IP: Logged |
|
Ice Man Pro Bodybuilder (Total posts: 314) |
posted June 07, 2000 10:41 AM
Happens all the time. Just shake it down to the bottom. IP: Logged |
|
MiracleMan Amateur Bodybuilder (Total posts: 83) |
posted June 07, 2000 11:05 AM
Hey, shake it down first, then warm up the ampule with some hot water, makes the oil base gear thinner, snap the neck off and draw it up with the pin. Then Jab. Good Luck IP: Logged |
|
Anabolicum Mister Pro Bodybuilder (Total posts: 255) |
posted June 07, 2000 09:00 PM
Hold the amp in one hand and keep flicking the top with a finger on the other hand (like you would flick someones earlobe) and the oil will run to the bottom half. IP: Logged |
All times are ET (US) | |
 |
|
|