GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 mixing dsmo with water why?
|
| Author | Topic: mixing dsmo with water why? |
|
omni Amateur Bodybuilder (Total posts: 7) |
posted May 31, 2000 11:30 AM
  
whats the reason for mixing it 50/50 with water i have done it with just dsmo and with mixing it with water. the only thing i can see is it burns a little less with water but wouldint it reduse the amount of tren that gets through the scin? IP: Logged |
|
decadon Pro Bodybuilder (Total posts: 179) |
posted May 31, 2000 05:47 PM
what kind of dmso are you using...99% is what I used and when I dabbed a little on my skin...it burned like a mofo...so you must have some kind of mix already IP: Logged |
|
omni Amateur Bodybuilder (Total posts: 7) |
posted May 31, 2000 11:10 PM
i've been using 99.9% dsmo but i've been using the gel. in the search i found an article that said somthing about the tren that mixes with the water dont pass through the skin and you can tell when the mixture becomes clouded after you mix the water in. and this happend to me so i started to just use it stright with no water. it burns a bit at first but i start getting used to it after the first week and it doesint bother me to much after that. i also though rotate between legs and have been know to rub it on my arm every now and then IP: Logged |
|
cockdezl Pro Bodybuilder (Total posts: 104) |
posted June 01, 2000 09:58 AM
First off, mixing DMSO that contains a steroid (I am assuming Tren) with water is not a good idea. If you notice, when you add water to this it turns white and cloudy. This is the drug precipitating out of solution. When this happens it is not going to pass through the skin. A better idea is to mix the DMSO with another chemical that tren is soluble in, say isopropyl alcohol or propylene glycol. This way you have no precipitation and both of the vehicles are known for there transdermal effects. IP: Logged |
|
WCP Pro Bodybuilder (Total posts: 984) |
posted June 01, 2000 12:34 PM
If you have the 99.9% gel, mixing with water is not necessary..just messy and does nothing for absorbtion.. WCP IP: Logged |
|
Verbal Gorilla Amateur Bodybuilder (Total posts: 3) |
posted June 01, 2000 01:43 PM
Not exactly. In just about every DMSO study, the maximum absorbtion through the skin was with a mix of DMSO at about 85-just under 90%. A higher yeild of DMSO actually negativly affected the absobtion quality. So, do the math, and get 87% DMSO, and 13% water... IP: Logged |
All times are ET (US) | |
 |
|
|