GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Is 1/2 inch dart long enough for Quad injection???
|
| Author | Topic: Is 1/2 inch dart long enough for Quad injection??? |
|
pillboy Amateur Bodybuilder (Total posts: 43) |
posted May 26, 2000 10:51 AM
  
Is 1/2 inch long enough for quad injection? Do you inject in vastus lateralis(outside sweep)? Too many injections in this cycle for all glute. Thanks IP: Logged |
|
lexicon Pro Bodybuilder (Total posts: 181) |
posted May 26, 2000 11:05 AM
It may work but would use a 1". Actually, think 1/2 is too small, gear will pour out. IP: Logged |
|
Bossman Amateur Bodybuilder (Total posts: 64) |
posted May 26, 2000 11:06 AM
I would use 1". With 1/2 you may get a lot under the skin and not in the muscle. IP: Logged |
|
matty Pro Bodybuilder (Total posts: 658) |
posted May 26, 2000 01:34 PM
dude its basicaly, common sense! if your lean enough with good deffintion yeah it will work, if you have a 1/2" layer of blubber coating your legs from the winter or what ever then no it wont work! stick the frickin pin in as far as it goes and youll know if its in the muscle or not, you should have 2 size pins b4 u start your cycle anyway ITS JUST THAT THIS TOPIC HAS BEEN SO DONE ALLREADY....!!! ------------------ IP: Logged |
|
GUNSG Amateur Bodybuilder (Total posts: 74) |
posted May 26, 2000 03:48 PM
NOT LONG ENOUGH IP: Logged |
|
Rich1 Pro Bodybuilder (Total posts: 386) |
posted May 26, 2000 03:52 PM
Use the 1.5" pins unless you can't get them or your afraid of the needle...You'll get over it, why run the risk of wasteing good gear??? IP: Logged |
|
BrickWall Amateur Bodybuilder (Total posts: 49) |
posted May 26, 2000 04:03 PM
1.5" FOR GLUTES 1" FOR UR LEGS 3/4" - 1" FOR DELTS 3/8" FOR UR TOUNGE (NOT RECOMMENDED -HEHE) -BW IP: Logged |
All times are ET (US) | |
 |
|
|