GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Info on injecting
|
| Author | Topic: Info on injecting |
|
hellraisr Amateur Bodybuilder (Total posts: 12) |
posted May 12, 2000 02:56 PM
 
This is a just a lil info that I hope will help some brothers out. I have been on Sust 3cc a week for 5 weeks now. First shot was a bitch because the oil was so thick. So the next shot I put the dart under my lamp about an inch away from the light bulb & 10 min later shit the oil was hot. Let me tell you it helps it go in so much better & lessens the pain. I was never keen on the idea of sticking the dart under the faucet for sterility reasons. I hope this lesson learned will help a future brother out! IP: Logged |
|
AY Amateur Bodybuilder (Total posts: 93) |
posted May 12, 2000 08:51 PM
I don't think that exposing your needle longer than you have to is a good idea. If I were you, I'd just put the sus containers into a cup filled with some warm water to warm up the oil. AY IP: Logged |
|
THE PROPHAT Amateur Bodybuilder (Total posts: 5) |
posted May 12, 2000 09:23 PM
a good way to get it in smoother....either soak the amps in a cup of warm h2o for a few mins priopr to drawing, or hold the pin with the sauce in it in your cupped hand for a few mins b4 sticking yourself...your body temp warms it....hoiwever....make sure its capped & your hands are very clean to avoid infection!!! IP: Logged |
All times are ET (US) | |
 |
|
|