GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 AMPULES OF SUSTANON READ THIS!!
|
| Author | Topic: AMPULES OF SUSTANON READ THIS!! |
|
SCHNiKEN Pro Bodybuilder (Total posts: 170) |
posted May 09, 2000 07:57 PM
  
I am about to break open some amps of cyctahoh.. ive seen some stuff about using a filter needle??? do i need to use this.. can someone point me in the direction of the proper way to draw steroids from a ampule.. ive searched already and cannot find it.. IP: Logged |
|
DROP THE HAMMER Amateur Bodybuilder (Total posts: 38) |
posted May 09, 2000 08:02 PM
CHECK YAHOO SEARCH ENGINE.. IP: Logged |
|
SCHNiKEN Pro Bodybuilder (Total posts: 170) |
posted May 09, 2000 08:11 PM
I just checked.. i couldnt come up with any answers to my question.. call me dum or whatever.. maybe im just not good at it.. can someone please just maybe point me in the right direction IP: Logged |
|
DROP THE HAMMER Amateur Bodybuilder (Total posts: 38) |
posted May 09, 2000 08:15 PM
EMAIL E2 FOR INFO... IP: Logged |
|
E2 Moderator (Total posts: 2886) |
posted May 09, 2000 08:17 PM
File the amp you need to with the cyctahoh, and you don't need a filter, it's clean stuff. IP: Logged |
|
conan69 Pro Bodybuilder (Total posts: 763) |
posted May 09, 2000 08:56 PM
no filter is needed just get a cheap file from the hardware store ------------------ IP: Logged |
|
Vlad67 Pro Bodybuilder (Total posts: 184) |
posted May 09, 2000 08:59 PM
cheap file.....pen cap over the top .... no worries.. VK IP: Logged |
|
bollocks Amateur Bodybuilder (Total posts: 83) |
posted May 09, 2000 09:08 PM
as for gettin it in the pin..... make sure the PIN is on right, take the top off the amp, take out the plunger and just pour it in. put back the plunger, let out the air....... start jabbin  look at 2 thick's page......good info !!! IP: Logged |
|
Anabolicum Mister Pro Bodybuilder (Total posts: 119) |
posted May 09, 2000 09:37 PM
You can draw from an amp just like a vial. I don't know how anyone pours an amp into a syringe. The way the amp is designed, you can hold it upside down and draw the juice out. I am not kidding. I heard about this and tried it to see if it worked and it did. It freaks you out because you think your going to lose the oil but it doesn't come out. I have even done this with water based winny, although towards the end I did spill a drop. It has to do with the surface tension of the liquid and the shape of the amp I believe. I don't know if there is any benefit to doing it this way other than the fact that you don't have to chase that last bit of juice around the bottom of the amp. If you care to try this method, make sure you have a clean level break, i.e. you have not snapped the top off at an angle. Anyone else ever try this? IP: Logged |
|
Jay Z Pro Bodybuilder (Total posts: 177) |
posted May 09, 2000 11:03 PM
done it...no spill ------------------ IP: Logged |
|
aten8 Pro Bodybuilder (Total posts: 165) |
posted May 09, 2000 11:10 PM
Yeah I don't think you can pour an amp. Just insert the needle and load no filter needed. IP: Logged |
All times are ET (US) | |
 |
|
|
