GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Kit users please respond
|
| Author | Topic: Kit users please respond |
|
vdevil Pro Bodybuilder (Total posts: 595) |
posted May 07, 2000 10:12 AM
   Hey all, just finished my kit. Wanted to verify and compare my results with some of you guys. The top 2/3 of my vial has a pretty solid golden color. The bottom 1/3 however is more orangeish-brown. Is this remaining glue ? Is it safe to inject? Would putting the vial into oven at 250 take care of this? Thanx in advance for any and all comments. IP: Logged |
|
E2 Moderator (Total posts: 2841) |
posted May 07, 2000 10:50 AM
You should filter it now, to get the glue out IP: Logged |
|
vdevil Pro Bodybuilder (Total posts: 595) |
posted May 07, 2000 12:11 PM
Actually, I already did. I drew all the fluid out of the number 1 vial(except for the gunk), and pushed it through the filter(supplied with the kit)into the sealed sterile vial. It looks like there still is some seperation. The fluid in the bottom one-third of the bottle is orange as unlike to golden like the rest. IP: Logged |
|
conan69 Pro Bodybuilder (Total posts: 722) |
posted May 07, 2000 12:21 PM
bro if you did it right the whole thing should be one color...like a golden brown kind of like scotch i guess(maybe a little darker) ------------------ IP: Logged |
|
dude Pro Bodybuilder (Total posts: 243) |
posted May 07, 2000 04:16 PM
If there is still some separation then heat it up in the oven. IP: Logged |
|
animal B Pro Bodybuilder (Total posts: 235) |
posted May 07, 2000 10:01 PM
Im laTE , what are you cooking up IP: Logged |
|
E2 Moderator (Total posts: 2841) |
posted May 08, 2000 10:59 AM
Dude is right, if there is separation after filtration then you heat it up and it will go back into suspension again, and it's shoulnd't be a dark brown, more like a yellow. Dark brown is indicative of old pellets or too much oxidation during the process. Which method did you use? IP: Logged |
All times are ET (US) | |
 |
|
|
