GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 injection question, i'd appreciate your help......
|
| Author | Topic: injection question, i'd appreciate your help...... |
|
BillyBadAss Amateur Bodybuilder (Total posts: 3) |
posted May 03, 2000 07:31 PM
  
okay guys i couldn't get the right size pin for primo and deca, i had to get a 23gx1. i couldn't get it to draw, so i pulled the plunger out and dumped the primo and deca into the syringe.then i just put the plunger back in and injected it.anything wrong with this?by the way, when should i start to notice 300mg primo depot and 200mg deca? 5'11 205 IP: Logged |
|
bstrong Pro Bodybuilder (Total posts: 159) |
posted May 03, 2000 07:36 PM
bro that's my favorit way to juice, saves ton of needls,just make sure u wont touch anything that is spose to be sterile IP: Logged |
|
BillyBadAss Amateur Bodybuilder (Total posts: 3) |
posted May 04, 2000 01:32 AM
im bumpin this IP: Logged |
|
Harleyguy Amateur Bodybuilder (Total posts: 73) |
posted May 04, 2000 01:45 AM
Hey bro,I'm on the exact same cycle as you are right now.300mg of Primo and 200mg of Deca for 8 weeks,I will also add Winny EOD for the last 4 weeks.I'm also using 23g 1 inch pins to inject,but I'm drawing the fluid with 18g 1 1/2 pins,it works great. As far as results go,this is a cycle that you need patience with.The results should start to kick in around week 4 or 5.Just train hard and smart and EAT EAT EAT,and you will grow.Good luck. IP: Logged |
All times are ET (US) | |
 |
|
|