GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
| Author | Topic: women cycles, how long | ||
|
Amateur Bodybuilder 
Posts: 102 |
I know the general way a man goes about his cycles, but how long should a woman be on lets say 10-20mg winstrol or anavar. My girlfriend wants to look like a rock hard fitness chick. I have given her some clen and t3 and she has gotten down to 11$ bodyfat. She would like to be between 8-9. Her diet is solid, and she has agreed to try some winny or anavar, what would be better, how many mg and for how long. Thanks     | ||
|
Elite Bodybuilder 
Posts: 987 |
ask over on the women's discussion board...someone over there should know | ||
|
Amateur Bodybuilder
Posts: 91 |
Personally, I would have her go with the anavar @ 10mgs a day for 6-8 wks. She could also add in some nolvadex to reduce bf/water retention. However, this is somewhat risky as manipulating estrogen in women can lead to hot flashes, menstrual irregularities and other problems with her reproductive system. BANSHEE | ||
|
Moderator 
Posts: 2595 |
DAmn guy, read up before you go doing shit like this. T3 AND clen without an anabolic?!? No wonder she is having a hard time looking hard. Looking hard requires muscle, and keeping muscle around with T3 is not likly. Getting a Lady down in the upper single digits is competion area. And building muscle while at that BF is damn near imposible. ------------------ Lobo | ||
|
Amateur Bodybuilder
Posts: 102 |
honestly she hasn't lost any muscle. She looks good as hell, but she wants to be shredded. | ||
|
Amateur Bodybuilder
Posts: 71 |
Is she competing? If not I would not recommend taking her bf below 10%. This is too low for a woman to maintain for any length of time. 10-11% is a bit low as it is. She may have health and hormonal problems at this level. I am female and have used Winstrol with some success. I would not want to take my bodyfat levels under 10% unless it were to be for a short time e.g. for contest or 'photos. |
All times are ET (US) | |
 |
|
|
posted April 19, 2001 01:41 PM