GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 23 G 1.5 good enough for primo ?
|
| Author | Topic: 23 G 1.5 good enough for primo ? | ||
|
Amateur Bodybuilder 
Posts: 62 |
I am gonna be using primobolan depot and a 23g 1.5 pin. Is this size good enough for drawing out the primo and then injecting ? Thank You...not asking which one you think is best , but if this one will suffice.     | ||
|
Pro Bodybuilder 
Posts: 558 |
Anything that will get it in your body will work. But 1.5" is big enough if going in the glute but might be too large for the quad, shoulder, or pec. | ||
|
Olympian 
Posts: 1964 |
no it is not good. You should use a 21 gauge for drawing and a 25 for shooting (after heating the syringe with hot water). And in most cases 1 inch is long enough (go high in the but). Or do what i do: remove the plunger and poor the stuff into the syringe. If using multiple syringes (doing 300 or 600 mgr/week) after filling the syringeS, poor the spare drops of the open amps in one am. You will be surprised of how much you will NOT spill. I always use a 2 cc syringe, a 25 gauge and a 5/8 inch needle, but you will need a 1 inch. ------------------ Don't look back, life is too short | ||
|
Olympian
Posts: 1964 |
Aahepp, you just beat me to it. I didn't refer to you. ------------------ Don't look back, life is too short | ||
|
Cool Novice 
Posts: 49 |
25 guage for shooting, follow Jeff's advice on everything. I do it the same way |
All times are ET (US) | |
 |
|
|
posted April 14, 2001 04:42 PM